> On 19 Sep 2017, at 15:47, Job <Job@xxxxxxxxxxxxxxxxxxxx> wrote: > > Hi guys, > > we need to insert from a table to another (Postgresql 9.6.1) a large amount of data (about 10/20 millions of rows) without locking destination table. > Pg_bulkload is the fastest way but it locks the table. > > Are there other ways? > Classic "COPY" from? We do something like that using a staging table to load to initially (although not bulk; data arrives in our staging table with batches of 5k to 100k rows) and then we transfer the data using insert/select and "on conflict do". That data-transfer within PG takes a couple of minutes on our rather limited VM for a wide 37M rows table (~37GB on disk). That only locks the staging table (during initial bulkload) and the rows in the master table that are currently being altered (during the insert/select). If your data-source is a file in a format supported by COPY, then you can use COPY to do the initial bulk load into the staging table. Some benefits of this 2-stage approach are that it leaves room to manipulate the data (type conversions, for example) and that it can handle the scenario where a matching target record in the master table already exists. In our case, we convert character fields to varchar (which saves a lot of space(s)). Alban Hertroys -- If you can't see the forest for the trees, cut the trees and you'll find there is no forest. -- Sent via pgsql-general mailing list (pgsql-general@xxxxxxxxxxxxxx) To make changes to your subscription: http://www.postgresql.org/mailpref/pgsql-general
