Thanks, there was a typo of the line "hot_standby", it works now, thanks again. On 6 Aug 2013, at 6:52 PM, Haribabu kommi wrote: > > On 06 August 2013 16:13 ascot.moss wrote >> Hi, > >> I just setup the replication in the slave again, when trying to use psql, I could not get the psql command prompt but got "psql: FATAL: the database system is starting up" from it. > >> PG: 9.2.4 > >> Below is the log from the the slave: >> LOG: database system was shut down in recovery at 2013-08-06 18:34:44 >> LOG: entering standby mode >> LOG: consistent recovery state reached at 1C/9A0F9CF0 >> LOG: record with zero length at 1C/9A0F9CF0 >> LOG: streaming replication successfully connected to primary >> FATAL: the database system is starting up > >> I am new to PG replication, please help. > > There is a configuration parameter "hot_standby" is set as on or not? > This allows the queries during recovery. > > Regards, > Hari babu. > -- Sent via pgsql-general mailing list (pgsql-general@xxxxxxxxxxxxxx) To make changes to your subscription: http://www.postgresql.org/mailpref/pgsql-general
