Chris Barnes wrote: >> Does anyone use solid state drives for postgres? >> Has there been any benchmark that states whether mechanical disk drives out perform solid state drives? >> Is there any benefit, they are quite expensive. I am currently running PostgreSQL 8.4.1 on a Mac Pro 2009 with a RAID 0 array consisting of 2 Intel X-25M 160G disks (50nm version). Assuming postgresql is running properly (Snow Leopard 64 bit seems to have created a few hassles) I get the following speed: 1) Up to around 10K random reads/second for small reads that are not CPU limited 2) Up to around 4K random writes/second for smallish writes that are not CPU limited 3) Around 400MB/second sustained read (with less than 600 read I/Os, and not CPU limited) 4) Around 140-160MB/second sustained writes [These are not the drive specs, they are what I observe in "Activity Monitor"] There is very little difference between sequential I/O and random I/O speeds for most practical applications, which is wonderful. Typically, in my normal environment, when postgres is busy, I see 2K - 3K reads / second, and up to 1K writes / second, as reported by "Activity Monitor". However, some things in postgresql run much slower than I would expect on my machine. pg_dump seems peak at only 60MB/s on the read side. And "VACUUM FULL" typically grinds along at only around 1MB/s on large tables. And each transaction seems to cause a delay. Under postgres, I'm not very happy with my transactions per second - but I don't really know what the bottleneck is here. My previous system was Linux MySQL on a RAID 5 array consisting of 6 x SCSI U320/ 15K disks. Performance was dominated by the random seek time, which was around 4ms for that system (100us for my current system). Most non-bulk operations are radically faster on the SSD. It could well be 40x faster under random I/O, but I haven't benchmarked it. And I can report that the SSD drives are radically quieter and cooler. My old system was like a leaf-blower (14 fans, kept the room warm). I can't even hear my SSDs :) The specification of my SSD drives is kind of depressing: http://www.intel.com/design/flash/nand/mainstream/technicaldocuments.htm "The drive will have a minimum of 5 years of useful life under typical client workloads with up to 20 GB of host writes per day." That equates to only 40TB cumulative writes, or only 228 complete drive rewrites. At that rate, I could wear out the drive in only 6 days of continuous, flat-out writing. But I'm hoping that the drive will be good for say 10,000 complete cumulative rewrites, or 1600TB per drive, as modern quality flash memory supports much more than 10K rewrites. The cost of the drives has already halved in the few months I have had them, so they should be virtually free by the time they wear out and need replacement :) So far I have encountered zero errors on the SSD drives, and SMART status is OK. The SCSI U320 15K drives have given a few soft errors over the past few years. Stephen -- Sent via pgsql-general mailing list (pgsql-general@xxxxxxxxxxxxxx) To make changes to your subscription: http://www.postgresql.org/mailpref/pgsql-general
