I have a single *table* that is some 560GB in size, 6 columns, average row width 63. There are approximately 6.1 billion rows. It has 4 indices, 131, 313, 131 and 190 GB in size, respectively. All are btree indices. I tried inserting new data into the table, and it's taking a *very* long time. I pre-built the data to be inserted into a temporary table with the exact same structure and column ordering, etc, and the temporary table is about 8.5GB in size with about 93 million rows. The temporary table was built in about 95 seconds. The insert has been going for 47 hours and 21 minutes, give or take. I'm not doing any correlation or filtering, etc -- straight up insert, literally "insert into big_table select * from the_temp_table;". vmstat output doesn't seem that useful, with disk wait being 10-15% and I/O speeds highly variable, from 5-20MB/s reads couple with 0-16MB/s writes, generally on the lower end of these. strace of the inserting process shows that it's basically hammering the disk in terms of random reads and infrequent writes. postgresql. It's not verifying, rebuilding, etc. While this process is active, streaming write I/O is terrible - 36MB/s. WIth it "paused" (via strace) I get 72MB/s. (reads are 350MB/s). The OS is Scientific Linux 6.2, and the version of postgresql is 9.1.4 - x86_64. There is nothing else of note happening on the box. The box is a quad CPU, dual-core each Xeon E5430 @ 2.66GHz with 32GB of RAM and a 3ware 9690 RAID 4TB RAID10 for the storage for What might be going on here? -- Jon -- Sent via pgsql-performance mailing list (pgsql-performance@xxxxxxxxxxxxxx) To make changes to your subscription: http://www.postgresql.org/mailpref/pgsql-performance
