Hello
We have an application that needs to do bulk reads of ENTIRE Postgres tables very quickly (i.e. select * from table). We have
observed that such sequential scans run two orders of magnitude slower than observed raw disk reads (5 MB/s versus 100 MB/s). Part
of this is due to the storage overhead we have observed in Postgres. In the example below, it takes 1 GB to store 350 MB of nominal
data. However that suggests we would expect to get 35 MB/s bulk read rates.
Observations using iostat and top during these bulk reads suggest that the queries are CPU bound, not I/O bound. In fact, repeating
the queries yields similar response times. Presumably if it were an I/O issue the response times would be much shorter the second
time through with the benefit of caching.
We have tried these simple queries using psql, JDBC, pl/java stored procedures, and libpq. In all cases the client code ran on the
same box as the server.
We have experimented with Postgres 8.1, 8.3 and 9.0.
We also tried playing around with some of the server tuning parameters such as shared_buffers to no avail.
Here is uname -a for a machine we have tested on:
Linux nevs-bdb1.fsl.noaa.gov 2.6.18-194.17.1.el5 #1 SMP Mon Sep 20 07:12:06 EDT 2010 x86_64 x86_64 x86_64 GNU/Linux
A sample dataset that reproduces these results looks like the following (there are no indexes):
Table "bulk_performance.counts"
Column | Type | Modifiers
--------+---------+-----------
i1 | integer |
i2 | integer |
i3 | integer |
i4 | integer |
There are 22 million rows in this case.
We HAVE observed that summation queries run considerably faster. In this case,
select sum(i1), sum(i2), sum(i3), sum(i4) from bulk_performance.counts
runs at 35 MB/s.
Our business logic does operations on the resulting data such that the output is several orders of magnitude smaller than the input.
So we had hoped that by putting our business logic into stored procedures (and thus drastically reducing the amount of data
flowing to the client) our throughput would go way up. This did not happen.
So our questions are as follows:
Is there any way using stored procedures (maybe C code that calls SPI directly) or some other approach to get close to the expected
35 MB/s doing these bulk reads? Or is this the price we have to pay for using SQL instead of some NoSQL solution. (We actually
tried Tokyo Cabinet and found it to perform quite well. However it does not measure up to Postgres in terms of replication, data
interrogation, community support, acceptance, etc).
Thanks
Dan Schaffer
Paul Hamer
Nick Matheson
begin:vcard
fn:Dan Schaffer
n:Schaffer;Dan
org:NOAA/OAR/Earth System Research Lab ;Aviation Branch
adr:;;R/GSD5 325 Broadway;Boulder;CO;80305;United States
title:Research Associate IV
tel;work:303-497-7252
x-mozilla-html:FALSE
version:2.1
end:vcard
--
Sent via pgsql-performance mailing list (pgsql-performance@xxxxxxxxxxxxxx)
To make changes to your subscription:
http://www.postgresql.org/mailpref/pgsql-performance
