Hi,
We are doing the performance test in two nodes system(active/standby). Now we find that the disk IO is very high but the CPU is low. Is there any method or tool to help us debug to find which function makes this issue?
We try to use the gprof but it does not help us. The result show the LWLockAssign（the shared buffer init） is called the most time. The other function is called no more that 33139. That seems no problem.
Could you please give any suggestion how to debug the high IO/low CPU issue?
Thanks
Steven
===================================
no time accumulated
% cumulative self self total
time seconds seconds calls Ts/call Ts/call name
0.00 0.00 0.00 9240928 0.00 0.00 LWLockAssign
0.00 0.00 0.00 33139 0.00 0.00 ShmemAlloc
0.00 0.00 0.00 33084 0.00 0.00 seg_alloc
….
On Fri, Sep 14, 2018 at 6:29 AM 范国腾 <fanguoteng@xxxxxxxxxx> wrote:
There are a few things you should investigate for a start, as you seem to be lifting more data than you probably should.
1) Check the sizes of your tables (in particular the number of rows) and identify the heaviest
2) With pgfouine or pgbadger, check which queries take most time and see if there is a correlation (there probably is)
3) Run EXPLAIN on these queries to see if you have a sequential scan on the whole table that should be optimized
4) Design indexes to relieve these queries (note that the queries will run faster but the INSERT on these tables will be heavier)
5) In postgresql.conf, check the following parameters:
* shared_buffers (I've set it to 1/4 of the RAM with good success)
* temp_buffers (you may need to experiment in double increments)
* work_mem (try to increase it too)
6) Check how often the autovacuum runs (could be another indicator)
Olivier
