I'm having issues running OpenConnect on a router I flashed with Asuswrt-Merlin. I have a USB drive connected with Entware-ng installed, and was able to install OpenConnect and related packages. The first time I run OpenConnect, I get some error about /etc/resolv.conf. Overwriting this file with a non-read-only duplicate seems to solve that. Next, it seems to run okay, but I can tell I'm not actually connected to the VPN because I still have the IP my ISP provided. I've tried adding in some "missing" routes based off of what I see when I run OpenConnect successfully on OSX, but then I can't connect to any sites at all. I've tried a lot of different things, but I don't know how helpful it is to list all of those out, and I'm not sure I can remember them all at this point. The VPN does seem to work correctly while SSH'd into the router itself if I run OpenConnect and add a route via the following: route add -net 0.0.0.0 netmask 0.0.0.0 gw x.x.x.x dev tun0 Where x.x.x.x is the same ip in this output: Connected as x.x.x.x, using SSL + lzs I then confirm that I'm getting the IP from the VPN via: wget http://checkip.dyndns.org/ | sed 's/[a-zA-Z<>/ :]//g' The other thing I had thought of is that when I use L2TP or OpenVPN from the router interface, the /etc/resolv/conf file doesn't change, whereas OpenConnect removes the default nameserver adds a couple other nameservers when it runs. I tried changing this back to the default nameserver, but that didn't seem to help. Any idea what's going wrong or thoughts on how I could troubleshoot this further?
