> AFAIK the banner is informational only, and clicking Continue on the > official client doesn't actually send anything back to the gateway. > > At my last job the banner was used to display an AUP / "authorized > access only" nag, and there were no ill effects when openconnect > ignored it. > > Perhaps something else is going wrong with your connection: wrong > authgroup, bad CSD response, old cert, etc.? How do I figure this out ? The verbose output does not mention any of these and I do end up getting a valid IP/resolv.conf/route table etc.. Thanks in Anticipation Regards Varad Gupta On Sat, Jan 31, 2015 at 12:07 AM, Kevin Cernekee <cernekee at gmail.com> wrote: > On Fri, Jan 30, 2015 at 9:33 AM, varad gupta <vbg at linux.com> wrote: >> I am trying to connect to a CISCO ASA VPN over SSL using openconnect. >> >> The authentication is certificate based.. The authentication phase >> passes successfully. Once Authenticated, the banner that comes, asks >> for continue/cancel to be selected. This option is visible on the web >> page as well and the Cisco client as well.. >> >> In openconnect, after successful auth, the banner is echoed, but how >> would one pass a particulat input (continue in this case). In the >> absence of selecting continue, I get the IP/Gateway etc, but am unable >> to be a part of the network.. >> >> Sample output below ==> >> >> CSTP connected. DPD 30, Keepalive 20 >> Connect Banner: >> | Select Continue/Accept to logon... >> | >> >> Connected tun0 as X.X.X.X, using SSL >> No work to do; sleeping for 20000 ms... >> Send CSTP Keepalive >> No work to do; sleeping for 10000 ms... >> >> >> ============== >> How do I "select" Continue.. Any help would be deeply appreciated.. > -- -- Regards Varad Gupta
