On Wed, 4 May 2016, Bjørn Mork wrote:
> "Robert P. J. Day" <rpjday@xxxxxxxxxxxxxx> writes:
>
> > just noticed that on my x86 system, when i do a:
> >
> > $ make defconfig
> >
> > under "Ethernet driver support", all the top-level vendor choices
> > (3com, adaptec and so on) all have Kconfig entries with:
> >
> > default y
> >
> > reasonably, for each vendor, all of their cards are not "default y"
> > (that would be kind of silly), but what is the logic behind making
> > each vendor selection "default y"?
>
> To avoid introducing build regressions with the introduction of these
> directories:
> http://lists.openwall.net/netdev/2011/08/23/41
>
> This is because these directories were retro-fitted to the Kbuild system
> for most ethernet drivers.
so am i correct in concluding that, if i'm working with kernel
config fragments, there is no need to add "# ... is not set" lines to
my fragments since, without an actual selected board, all those
"default y" vendor settings have no effect?
rday
--
========================================================================
Robert P. J. Day Ottawa, Ontario, CANADA
http://crashcourse.ca
Twitter: http://twitter.com/rpjday
LinkedIn: http://ca.linkedin.com/in/rpjday
========================================================================_______________________________________________
Kernelnewbies mailing list
Kernelnewbies@xxxxxxxxxxxxxxxxx
http://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies
