I am working on porting linux kernel 3.4 to an arm926-ejs based fpga board.
After the kernel bootup, in the command prompt when i am using the command "ps -l "..i am getting the following
sh-4.2# ps -l
Unknown HZ value! (744514) Assume 100.
F S UID PID PPID C PRI NI ADDR SZ WCHAN TTY TIME CMD
0 S 0 51 1 0 80 0 - 443 wait ttySAC0 00:00:12 sh
0 R 0 56 51 0 80 0 - 297 - ttySAC0 00:00:04 ps
The issue i am facing is "I configured the jiffies for 25Hz,still it is assuming 100hz."
Is this problem related to the filesystem i am using.
I am using ".ext2" filesystem build from buildroot.
The option set in buildroot for creating filesystem are as mentioned below:
(3.4) linux version
uClibc C library Version (uClibc 0.9.33.x)
Binutils Version (binutils 2.21.1)
GCC compiler Version (gcc 4.7.x)
Will this issue be fixed If i use glibc nstead of uclibc in buildroot ?
Thanks,
Karthik.
_______________________________________________ Kernelnewbies mailing list Kernelnewbies@xxxxxxxxxxxxxxxxx http://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies
