On Sun, Oct 23, 2011 at 11:20:03PM -0400, Greg Freemyer wrote: > On Sun, Oct 23, 2011 at 1:34 PM, sri <bskmohan@xxxxxxxxx> wrote: > > No, uname did not show anything. > > Is there any way to get the kernel preemption mode, programatically? > > > > Thanks, > > --Sri > > > > On Fri, Oct 21, 2011 at 6:41 PM, Daniel Baluta <daniel.baluta@xxxxxxxxx> > > wrote: > >> > >> On Fri, Oct 21, 2011 at 2:28 PM, sri <bskmohan@xxxxxxxxx> wrote: > >> > Hi, > >> > > >> > Am using kernel 2.6.18-195(centos 5.5). > >> > My kernel configs have CONFIG_PREEMPT_NONE=7 and > >> > "CONFIG_PREEMPT_VOLUNTERY > >> > is not set". > >> > How to check that preemption is really in place? > >> > Is there any way to check my kernel is configured with what preemption > >> > levels? > >> > >> Hmm, uname -a? > I'm sure its in /sys somewhere. I do not think so. > Remember /sys is part of the official ABI. As documented in Documentation/ABI/, so perhaps you can read there. > Also, you see what your config look like for sure by looking at > /proc/config.gz (that file is virtual, but shows the contents of how > your config file was at compile time for the running kernel. Not all distros enable this :( I think the question needs to really be stated, why, from userspace, does it matter if preempt is enabled or not? This should never be something that userspace cares about at all. greg k-h _______________________________________________ Kernelnewbies mailing list Kernelnewbies@xxxxxxxxxxxxxxxxx http://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies
