Hi Vaibhav, On Mon, Jul 25, 2011 at 3:17 PM, Vaibhav Jain <vjoss197@xxxxxxxxx> wrote: > Hi, > > I read a few articles on linux virtual memory management such as this one : > http://lwn.net/Articles/75174/ > > which say that earlier linux kernel could only use memory slightly below 1 > GB. They have > given the reason for it but I am unable to understand.They further describe > the use of High memory and low memory. > Could anybody please explain the reason for kernel not being able to use the > 1 GB completely? > Also please provide references for high memory and low memory. My numbers/comments are for the ARM processor, the x86 may be slightly different. The typical configuration for the kernel has addresses from 0x00000000 through 0xC0000000 given to user space (it's actually a small amount less than 3 GB since modules are loaded in the space just before 0xC0000000). That leaves 0xC0000000 to 0xFFFFFFFF for kernel virtual memory (or 1 Gb). Now devices need some I/O space, which takes away from the 1Gb. I think what you're calling low memory is kernel logical memory. See http://lwn.net/images/pdf/LDD3/ch15.pdf on page 414 (not the 414th page of the PDF, but the page with 414 printed on the bottom). High memory is memory which is not directly accessible by the kernel. You need to use kmap/kunmap to map the memory into the kernel virtual memory space. Low memory is always accessible by the kernel. So user-mode programs get allocated from high-memory (if high memory exists) since the kernel doesn't typically need to access the user-space memory. It is possible to set some CONFIG options and have the 3Gb/1Gb split changed to 2Gb/2Gb or 1Gb/3Gb, but 3Gb/1Gb is the normal default. -- Dave Hylands Shuswap, BC, Canada http://www.davehylands.com _______________________________________________ Kernelnewbies mailing list Kernelnewbies@xxxxxxxxxxxxxxxxx http://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies
