On Mon, Jun 27, 2011 at 9:57 AM, sri <bskmohan@xxxxxxxxx> wrote: > Hi, > > One of my devices runs with Centos 5.3 kernel (kernel-2.6.18-128.el5) and > that box stops responding occasionally. > When did hard reboot, it comes to normal execution. I would like to see > which device failure caused the box to stop rebooting. > I would like to see the POST process execution (if enabled) during the > centos kernel boot time. > Is there any kernel config for POST? > > Any suggestions are appreciated. > > Thanks, > -- > -- > Krishna Mohan B > > _______________________________________________ > Kernelnewbies mailing list > Kernelnewbies@xxxxxxxxxxxxxxxxx > http://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies > > I am afraid POST is kernel independent feature. Power-On-Self-Test runs immediately after power applied and, if all went well, invokes bootstrapping code. Verbosity of POST is mainly configured into BIOS. Make sure you set up maximum verbosity level. To get information about what cause your system not responding it is better to look up kernel messages. You provide poor information to make any conclusion or even guessing. Sorry. When you box is friezed try to invoke "magic keys" (http://en.wikipedia.org/wiki/Magic_SysRq_key) to collect some information. P.S. Sorry for my English _______________________________________________ Kernelnewbies mailing list Kernelnewbies@xxxxxxxxxxxxxxxxx http://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies
