hi did you check your initial console? what do you get on kernel 2.4 when you say: cat /proc/cmdline May be the name for your initial console changed from ttyS0 (2.4) to ttySMX0 (2.6) or some thing similar. Probably you will find the name for it in drivers/serial/the_driver_which_is_used_for_your_board.c It is just an assumption ... TR Am Montag, den 09.03.2009, 20:38 +0100 schrieb Ole Loots: > Hello there, > > we are developing an board for the dnp9200 SOC > (http://www.dilnetpc.com/dnp0069.htm). > > We got kernel 2.4.27 running with the board, boots fine, serial port is > working, ethernet is working, everything is good. > but when i try to boot kernel 2.6.10, it hangs. > > What could be the cause? io pin reset states? Bus pin reset states? > > > this is how far kernel 2.6.10 boots: > Loading Ramdisk at 101f8c3c - 1039e29b, to 20408000 - 205ad65f ... OK > > Starting kernel ... > [hang] > > My question: how could i debug the boot process? In which files could I put > some printk's to see where the kernel hangs? > > > Greets and regards, > > Ole > > -- > To unsubscribe from this list: send an email with > "unsubscribe kernelnewbies" to ecartis@xxxxxxxxxxxx > Please read the FAQ at http://kernelnewbies.org/FAQ > > -- To unsubscribe from this list: send an email with "unsubscribe kernelnewbies" to ecartis@xxxxxxxxxxxx Please read the FAQ at http://kernelnewbies.org/FAQ
