hi to all
i am trying for huawei EC321 datacard on my laptop after inserting it dmesg is showing ..
pccard: CardBus card inserted into slot 0
ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
PCI: Enabling device 0000:05:00.0 (0000 -> 0002)
ACPI: PCI Interrupt 0000:05:00.0[A] -> GSI 16 (level, low) -> IRQ 185
PCI: Setting latency timer of device 0000:05:00.0 to 64
ohci_hcd 0000:05:00.0: OHCI Host Controller
ohci_hcd 0000:05:00.0: new USB bus registered, assigned bus number 6
ohci_hcd 0000:05:00.0: irq 185, io mem 0x92000000
usb usb6: configuration #1 chosen from 1 choice
hub 6-0:1.0: USB hub found
hub 6-0:1.0
: 1 port detected
PCI: Enabling device 0000:05:00.1 (0000 -> 0002)
ACPI: PCI Interrupt 0000:05:00.1[B] -> GSI 16 (level, low) -> IRQ 185
PCI: Setting latency timer of device 0000:05:00.1 to 64
ohci_hcd 0000:05:
00.1: OHCI Host Controller
ohci_hcd 0000:05:00.1: new USB bus registered, assigned bus number 7
ohci_hcd 0000:05:00.1: irq 185, io mem 0x92001000
usb usb7: configuration #1 chosen from 1 choice
hub 7-0:1.0: USB hub found
hub 7-0:1.0: 1 port detected
usb 6-1: new full speed USB device using ohci_hcd and address 2
hub 6-0:1.0: Cannot enable port 1. Maybe the USB cable is bad?
hub 6-0:1.0: Cannot enable port 1. Maybe the USB cable is bad?
hub 6-0:1.0: Cannot enable port 1. Maybe the USB cable is bad?
input: Virtual ThinkFinger Keyboard as /class/input/input4
hub 6-0:1.0: Cannot enable port 1. Maybe the USB cable is bad?
usb 6-1: new full speed USB device using ohci_hcd and address 6
usb 6-1: configuration #1 chosen from 1 choice
usbcore: registered new driver usbserial
drivers/usb/serial/usb-serial.c: USB Serial support registered for generic
usbcore: registered new driver usbserial_generic
drivers/usb/serial/usb-serial.c: USB Serial Driver core
drivers/usb/serial/usb-serial.c: USB Serial support registered for Option 3G dat a card
option 6-1:1.0: Option 3G data card converter detected
usb 6-1: Option 3G data card converter now attached to ttyUSB0
option 6-1:
1.1: Option 3G data card converter detected
usb 6-1: Option 3G data card converter now attached to ttyUSB1
usbcore: registered new driver option
drivers/usb/serial/option.c: Option Card (PC-Card to) USB to Serial Driver:
v0.4
what it means hub 6-0:1.0: Cannot enable port 1. Maybe the USB cable is bad?
is it my kernel is not supporting or problem of my hardware.?