Steve Iribarne schrieb:
no it isn't very big, but i didn't change anything but the vga-entry.it would help a ton if you posted your lilo.conf. It's not a that big is it?
Are you redirecting the output to another console?
In my case there where no problems but the one that linux didn't display the messages at
boottime.
here is my lilo.ocnf:
# LILO configuration file # generated by 'liloconfig' # # Start LILO global section boot = /dev/hda1 message = /boot/boot_message.txt prompt timeout = 1200 # Override dangerous defaults that rewrite the partition table: change-rules reset # VESA framebuffer console @ 1024x768x256 # vga = 773 # Normal VGA console vga = normal # VESA framebuffer console @ 1024x768x64k # vga=791 # VESA framebuffer console @ 1024x768x32k # vga=790 # VESA framebuffer console @ 1024x768x256 # vga=773 # VESA framebuffer console @ 800x600x64k # vga=788 # VESA framebuffer console @ 800x600x32k # vga=787 # VESA framebuffer console @ 800x600x256 # vga=771 # VESA framebuffer console @ 640x480x64k # vga=785 # VESA framebuffer console @ 640x480x32k # vga=784 # VESA framebuffer console @ 640x480x256 # vga=769 # End LILO global section # Linux bootable partition config begins image = /boot/vmlinuz root = /dev/hda1 label = Linux read-only # Linux bootable partition config ends # Linux 2.6.9 image = /boot/linux269 root= /dev/hda1 label = Linux_2.6.9 read-only
-- Kernelnewbies: Help each other learn about the Linux kernel. Archive: http://mail.nl.linux.org/kernelnewbies/ FAQ: http://kernelnewbies.org/faq/
