I'm taking a stab at answering my own question about using the FIB to
filter unwanted packets, as suggested by BCP-38.
Assumption: the FIB (routing table) has entries for all inside networks
with proper gateway entries. For many edge routers, the FIB gains
information from the network interfaces configurations. One of those
network interfaces is the WAN, or uplink, interface.
Assumption: Non-routed netblocks are in the FIB as "black hole". Ditto
netblocks that are administratively blocked.
Section 3 of BCP-38 talks about restricting forged traffic.
* edge router MUST NOT send any packet with a source address
not in the router itself or in the inside network.
* edge router MUST NOT send broadcast packets upstream
* edge router MAY drop received upstream broadcast packet
So my attempt at blocking bad traffic looks something like this:
define wan0 = enp1s0
table inet filter {
chain wan_prerouting {
fib saddr . mark oif $wan0 counter drop # no in-n-out
fib daddr . iif type broadcast counter drop # no non-unicast
fib daddr . iif type anycast counter drop
fib daddr . iif type multicast counter drop
fib daddr . iif type blackhole counter drop
fib daddr . iif type unreachable counter drop
fib daddr . iif type prohibit counter drop
}
chain wan_output {
fib saddr . iif type broadcast counter drop # no non-unicast
#fib saddr . iif type anycast counter drop (unicast)
fib saddr . iif type multicast counter drop
fib saddr . iif type blackhole counter drop
fib saddr . iif type unreachable counter drop
fib saddr . iif type prohibit counter dro
}
chain prerouting {
type filter hook prerouting priority 0; policy accept;
iifname $wan0 jump wan_prerouting
}
chain output {
type filter hook output priority 0; policy accept;
iifname $wan0 jump wan_output
}
For those edge routers with full BGP tables, this netfilter code should
block packets from being sent to subnet broadcast addresses.
