Subject: [merged] cciss-set-max-scatter-gather-entries-to-32-on-p600.patch removed from -mm tree To: mike.miller@xxxxxx,axboe@xxxxxxxxx,bubrown@xxxxxxxxxx,steve.cameron@xxxxxx,thenzl@xxxxxxxxxx,mm-commits@xxxxxxxxxxxxxxx From: akpm@xxxxxxxxxxxxxxxxxxxx Date: Thu, 12 Sep 2013 12:42:07 -0700 The patch titled Subject: cciss: set max scatter gather entries to 32 on P600 has been removed from the -mm tree. Its filename was cciss-set-max-scatter-gather-entries-to-32-on-p600.patch This patch was dropped because it was merged into mainline or a subsystem tree ------------------------------------------------------ From: Mike Miller <mike.miller@xxxxxx> Subject: cciss: set max scatter gather entries to 32 on P600 At one time we used to set the maximum number of scatter gather elements on all Smart Array controllers to 32. At some point in time the firmware began to write the "appropriate" value for each controller into the config table. The cciss driver would then read that and set h->maxsgentries. h->maxsgentries = readl(&(h->cfgtable->MaxSGElements); On the P600 that value is 544. Under some workloads a significant performance reduction may result. This patch forces the P600 to use only 32 scatter gather elements. Other controllers are not affected. Signed-off-by: Mike Miller <mike.miller@xxxxxx> Signed-off-by: Dwight (Bud) Brown <bubrown@xxxxxxxxxx> Signed-off-by: Tomas Henzl <thenzl@xxxxxxxxxx> Acked-by: Stephen M. Cameron <steve.cameron@xxxxxx> Cc: Jens Axboe <axboe@xxxxxxxxx> Signed-off-by: Andrew Morton <akpm@xxxxxxxxxxxxxxxxxxxx> --- drivers/block/cciss.c | 7 +++++++ 1 file changed, 7 insertions(+) diff -puN drivers/block/cciss.c~cciss-set-max-scatter-gather-entries-to-32-on-p600 drivers/block/cciss.c --- a/drivers/block/cciss.c~cciss-set-max-scatter-gather-entries-to-32-on-p600 +++ a/drivers/block/cciss.c @@ -4258,6 +4258,13 @@ static void cciss_find_board_params(ctlr h->nr_cmds = h->max_commands - 4 - cciss_tape_cmds; h->maxsgentries = readl(&(h->cfgtable->MaxSGElements)); /* + * The P600 may exhibit poor performnace under some workloads + * if we use the value in the configuration table. Limit this + * controller to MAXSGENTRIES (32) instead. + */ + if (h->board_id == 0x3225103C) + h->maxsgentries = MAXSGENTRIES; + /* * Limit in-command s/g elements to 32 save dma'able memory. * Howvever spec says if 0, use 31 */ _ Patches currently in -mm which might be from mike.miller@xxxxxx are origin.patch -- To unsubscribe from this list: send the line "unsubscribe mm-commits" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html