The patch titled rapidio-add-rapidio-documentation-v2 has been removed from the -mm tree. Its filename was rapidio-add-rapidio-documentation-v2.patch This patch was dropped because it was folded into rapidio-add-rapidio-documentation.patch The current -mm tree may be found at http://userweb.kernel.org/~akpm/mmotm/ ------------------------------------------------------ Subject: rapidio-add-rapidio-documentation-v2 From: Alexandre Bounine <alexandre.bounine@xxxxxxx> Signed-off-by: Alexandre Bounine <alexandre.bounine@xxxxxxx> Cc: Kumar Gala <galak@xxxxxxxxxxxxxxxxxxx> Cc: Matt Porter <mporter@xxxxxxxxxxxxxxxxxxx> Cc: Randy Dunlap <rdunlap@xxxxxxxxxxxx> Signed-off-by: Andrew Morton <akpm@xxxxxxxxxxxxxxxxxxxx> --- Documentation/rapidio/sysfs.txt | 17 ++++++++++++++--- 1 file changed, 14 insertions(+), 3 deletions(-) diff -puN Documentation/rapidio/sysfs.txt~rapidio-add-rapidio-documentation-v2 Documentation/rapidio/sysfs.txt --- a/Documentation/rapidio/sysfs.txt~rapidio-add-rapidio-documentation-v2 +++ a/Documentation/rapidio/sysfs.txt @@ -36,6 +36,10 @@ device_rev - returns the device revision asm_did - returns identifier for the assembly containing the device asm_rev - returns revision level of the assembly containing the device asm_vid - returns vendor identifier of the assembly containing the device + destid - returns device destination ID assigned by the enumeration routine + (see 4.1 for switch specific details) + lprev - returns name of previous device (switch) on the path to the device + that that owns this attribute In addition to the files listed above, each device has a binary attribute file that allows read/write access to the device configuration registers using @@ -66,9 +70,16 @@ set by the switch initialization routine 4.1 Common Switch Attributes - routes - reports switch routing information in "destID port" format. This - attribute reports only valid routing table entries, one line for - each entry. + routes - reports switch routing information in "destID port" format. This + attribute reports only valid routing table entries, one line for + each entry. + destid - device destination ID that defines a route to the switch + hopcount - number of hops on the path to the switch + lnext - returns names of devices linked to the switch except one of a device + linked to the ingress port (reported as "lprev"). This is an array + names with number of lines equal to number of ports in switch. If + a switch port has no attached device, returns "null" instead of + a device name. 4.2 Device-specific Switch Attributes _ Patches currently in -mm which might be from alexandre.bounine@xxxxxxx are rapidio-add-new-sysfs-attributes.patch rapidio-add-rapidio-documentation.patch rapidio-add-architecture-specific-callbacks.patch rapidio-modify-configuration-to-support-pci-srio-controller.patch rapidio-modify-configuration-to-support-pci-srio-controller-fix-configuration-option.patch rapidio-modify-subsystem-and-driver-initialization-sequence.patch rapidio-modify-mport-id-assignment.patch rapidio-remove-mport-resource-reservation-from-common-rio-code.patch rapidio-fix-potential-null-deref-on-failure-path.patch -- To unsubscribe from this list: send the line "unsubscribe mm-commits" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html