The patch titled
dma-mapping: update the old macro DMA_nBIT_MASK related documentations
has been removed from the -mm tree. Its filename was
update-the-old-macro-dma_nbit_mask-related-documentations.patch
This patch was dropped because it was merged into mainline or a subsystem tree
The current -mm tree may be found at http://userweb.kernel.org/~akpm/mmotm/
------------------------------------------------------
Subject: dma-mapping: update the old macro DMA_nBIT_MASK related documentations
From: Yang Hongyang <yanghy@xxxxxxxxxxxxxx>
Update the old macro DMA_nBIT_MASK related documentations
Signed-off-by: Yang Hongyang<yanghy@xxxxxxxxxxxxxx>
Signed-off-by: Andrew Morton <akpm@xxxxxxxxxxxxxxxxxxxx>
---
Documentation/DMA-mapping.txt | 18 ++++++------
Documentation/DocBook/writing-an-alsa-driver.tmpl | 8 ++---
2 files changed, 13 insertions(+), 13 deletions(-)
diff -puN Documentation/DMA-mapping.txt~update-the-old-macro-dma_nbit_mask-related-documentations Documentation/DMA-mapping.txt
--- a/Documentation/DMA-mapping.txt~update-the-old-macro-dma_nbit_mask-related-documentations
+++ a/Documentation/DMA-mapping.txt
@@ -136,7 +136,7 @@ exactly why.
The standard 32-bit addressing PCI device would do something like
this:
- if (pci_set_dma_mask(pdev, DMA_32BIT_MASK)) {
+ if (pci_set_dma_mask(pdev, DMA_BIT_MASK(32))) {
printk(KERN_WARNING
"mydev: No suitable DMA available.\n");
goto ignore_this_device;
@@ -155,9 +155,9 @@ all 64-bits when accessing streaming DMA
int using_dac;
- if (!pci_set_dma_mask(pdev, DMA_64BIT_MASK)) {
+ if (!pci_set_dma_mask(pdev, DMA_BIT_MASK(64))) {
using_dac = 1;
- } else if (!pci_set_dma_mask(pdev, DMA_32BIT_MASK)) {
+ } else if (!pci_set_dma_mask(pdev, DMA_BIT_MASK(32))) {
using_dac = 0;
} else {
printk(KERN_WARNING
@@ -170,14 +170,14 @@ the case would look like this:
int using_dac, consistent_using_dac;
- if (!pci_set_dma_mask(pdev, DMA_64BIT_MASK)) {
+ if (!pci_set_dma_mask(pdev, DMA_BIT_MASK(64))) {
using_dac = 1;
consistent_using_dac = 1;
- pci_set_consistent_dma_mask(pdev, DMA_64BIT_MASK);
- } else if (!pci_set_dma_mask(pdev, DMA_32BIT_MASK)) {
+ pci_set_consistent_dma_mask(pdev, DMA_BIT_MASK(64));
+ } else if (!pci_set_dma_mask(pdev, DMA_BIT_MASK(32))) {
using_dac = 0;
consistent_using_dac = 0;
- pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK);
+ pci_set_consistent_dma_mask(pdev, DMA_BIT_MASK(32));
} else {
printk(KERN_WARNING
"mydev: No suitable DMA available.\n");
@@ -192,7 +192,7 @@ check the return value from pci_set_cons
Finally, if your device can only drive the low 24-bits of
address during PCI bus mastering you might do something like:
- if (pci_set_dma_mask(pdev, DMA_24BIT_MASK)) {
+ if (pci_set_dma_mask(pdev, DMA_BIT_MASK(24))) {
printk(KERN_WARNING
"mydev: 24-bit DMA addressing not available.\n");
goto ignore_this_device;
@@ -213,7 +213,7 @@ most specific mask.
Here is pseudo-code showing how this might be done:
- #define PLAYBACK_ADDRESS_BITS DMA_32BIT_MASK
+ #define PLAYBACK_ADDRESS_BITS DMA_BIT_MASK(32)
#define RECORD_ADDRESS_BITS 0x00ffffff
struct my_sound_card *card;
diff -puN Documentation/DocBook/writing-an-alsa-driver.tmpl~update-the-old-macro-dma_nbit_mask-related-documentations Documentation/DocBook/writing-an-alsa-driver.tmpl
--- a/Documentation/DocBook/writing-an-alsa-driver.tmpl~update-the-old-macro-dma_nbit_mask-related-documentations
+++ a/Documentation/DocBook/writing-an-alsa-driver.tmpl
@@ -1137,8 +1137,8 @@
if (err < 0)
return err;
/* check PCI availability (28bit DMA) */
- if (pci_set_dma_mask(pci, DMA_28BIT_MASK) < 0 ||
- pci_set_consistent_dma_mask(pci, DMA_28BIT_MASK) < 0) {
+ if (pci_set_dma_mask(pci, DMA_BIT_MASK(28)) < 0 ||
+ pci_set_consistent_dma_mask(pci, DMA_BIT_MASK(28)) < 0) {
printk(KERN_ERR "error to set 28bit mask DMA\n");
pci_disable_device(pci);
return -ENXIO;
@@ -1252,8 +1252,8 @@
err = pci_enable_device(pci);
if (err < 0)
return err;
- if (pci_set_dma_mask(pci, DMA_28BIT_MASK) < 0 ||
- pci_set_consistent_dma_mask(pci, DMA_28BIT_MASK) < 0) {
+ if (pci_set_dma_mask(pci, DMA_BIT_MASK(28)) < 0 ||
+ pci_set_consistent_dma_mask(pci, DMA_BIT_MASK(28)) < 0) {
printk(KERN_ERR "error to set 28bit mask DMA\n");
pci_disable_device(pci);
return -ENXIO;
_
Patches currently in -mm which might be from yanghy@xxxxxxxxxxxxxx are
origin.patch
--
To unsubscribe from this list: send the line "unsubscribe mm-commits" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
