The patch titled mtd/physmap: make physmap compat explicit has been added to the -mm tree. Its filename is mtd-physmap-make-physmap-compat-explicit.patch Before you just go and hit "reply", please: a) Consider who else should be cc'ed b) Prefer to cc a suitable mailing list as well c) Ideally: find the original patch on the mailing list and do a reply-to-all to that, adding suitable additional cc's *** Remember to use Documentation/SubmitChecklist when testing your code *** See http://userweb.kernel.org/~akpm/stuff/added-to-mm.txt to find out what to do about this The current -mm tree may be found at http://userweb.kernel.org/~akpm/mmotm/ ------------------------------------------------------ Subject: mtd/physmap: make physmap compat explicit From: Mike Frysinger <vapier@xxxxxxxxxx> The current method for always showing physmap compat address, size, and width is a bit confusing. If length is set to 0, then the address and width are still shown but silently unused. The physmap code itself already has logic which sets compat based on length, so just pull that out and into the Kconfig to make everything clear. Signed-off-by: Mike Frysinger <vapier@xxxxxxxxxx> Cc: Bryan Wu <Bryan.Wu@xxxxxxxxxx> Cc: David Woodhouse <dwmw2@xxxxxxxxxxxxx> Signed-off-by: Andrew Morton <akpm@xxxxxxxxxxxxxxxxxxxx> --- drivers/mtd/maps/Kconfig | 17 ++++++++++++++--- drivers/mtd/maps/physmap.c | 16 ++++------------ 2 files changed, 18 insertions(+), 15 deletions(-) diff -puN drivers/mtd/maps/Kconfig~mtd-physmap-make-physmap-compat-explicit drivers/mtd/maps/Kconfig --- a/drivers/mtd/maps/Kconfig~mtd-physmap-make-physmap-compat-explicit +++ a/drivers/mtd/maps/Kconfig @@ -23,9 +23,20 @@ config MTD_PHYSMAP To compile this driver as a module, choose M here: the module will be called physmap. +config MTD_PHYSMAP_COMPAT + bool "Physmap compat support" + depends on MTD_PHYSMAP + default n + help + Setup a simple mapping via the Kconfig options. Normally the + physmap configuration options are done via your board's + resource file. + + If unsure, say N here. + config MTD_PHYSMAP_START hex "Physical start address of flash mapping" - depends on MTD_PHYSMAP + depends on MTD_PHYSMAP_COMPAT default "0x8000000" help This is the physical memory location at which the flash chips @@ -37,7 +48,7 @@ config MTD_PHYSMAP_START config MTD_PHYSMAP_LEN hex "Physical length of flash mapping" - depends on MTD_PHYSMAP + depends on MTD_PHYSMAP_COMPAT default "0" help This is the total length of the mapping of the flash chips on @@ -51,7 +62,7 @@ config MTD_PHYSMAP_LEN config MTD_PHYSMAP_BANKWIDTH int "Bank width in octets" - depends on MTD_PHYSMAP + depends on MTD_PHYSMAP_COMPAT default "2" help This is the total width of the data bus of the flash devices diff -puN drivers/mtd/maps/physmap.c~mtd-physmap-make-physmap-compat-explicit drivers/mtd/maps/physmap.c --- a/drivers/mtd/maps/physmap.c~mtd-physmap-make-physmap-compat-explicit +++ a/drivers/mtd/maps/physmap.c @@ -261,14 +261,7 @@ static struct platform_driver physmap_fl }; -#ifdef CONFIG_MTD_PHYSMAP_LEN -#if CONFIG_MTD_PHYSMAP_LEN != 0 -#warning using PHYSMAP compat code -#define PHYSMAP_COMPAT -#endif -#endif - -#ifdef PHYSMAP_COMPAT +#ifdef CONFIG_MTD_PHYSMAP_COMPAT static struct physmap_flash_data physmap_flash_data = { .width = CONFIG_MTD_PHYSMAP_BANKWIDTH, }; @@ -312,7 +305,7 @@ static int __init physmap_init(void) int err; err = platform_driver_register(&physmap_flash_driver); -#ifdef PHYSMAP_COMPAT +#ifdef CONFIG_MTD_PHYSMAP_COMPAT if (err == 0) platform_device_register(&physmap_flash); #endif @@ -322,7 +315,7 @@ static int __init physmap_init(void) static void __exit physmap_exit(void) { -#ifdef PHYSMAP_COMPAT +#ifdef CONFIG_MTD_PHYSMAP_COMPAT platform_device_unregister(&physmap_flash); #endif platform_driver_unregister(&physmap_flash_driver); @@ -336,8 +329,7 @@ MODULE_AUTHOR("David Woodhouse <dwmw2@in MODULE_DESCRIPTION("Generic configurable MTD map driver"); /* legacy platform drivers can't hotplug or coldplg */ -#ifndef PHYSMAP_COMPAT +#ifndef CONFIG_MTD_PHYSMAP_COMPAT /* work with hotplug and coldplug */ MODULE_ALIAS("platform:physmap-flash"); #endif - _ Patches currently in -mm which might be from vapier@xxxxxxxxxx are linux-next.patch linux-timexh-cleanup-for-userspace.patch m25p80-fix-detection-of-spi-parts.patch m25p80-fix-detection-of-m25p16-flashes.patch mtd-physmap-make-physmap-compat-explicit.patch linux-serialh-touchup-for-userspace.patch -- To unsubscribe from this list: send the line "unsubscribe mm-commits" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html