The patch titled drivers/net/skge.c: restart the interface when it's options or pauseparam is set has been removed from the -mm tree. Its filename was driver-net-skgec-restart-the-interface-when-its-options-or-pauseparam-is-set.patch This patch was dropped because it was merged into mainline or a subsystem tree The current -mm tree may be found at http://userweb.kernel.org/~akpm/mmotm/ ------------------------------------------------------ Subject: drivers/net/skge.c: restart the interface when it's options or pauseparam is set From: "Xiaoming.Zhang" <Xiaoming.Zhang@xxxxxxxxxxxxxx> We have an issue of the skge driver: The card won't work when it's options are changed. Here's the hardware info: # lspci -v 05:04.0 Ethernet controller: Marvell Technology Group Ltd. 88E8001 Gigabit Ethernet Controller (rev 13) Subsystem: Marvell Technology Group Ltd. Marvell RDK-8001 Flags: bus master, 66MHz, medium devsel, latency 32, IRQ 16 Memory at d042c000 (32-bit, non-prefetchable) [size=16K] I/O ports at d000 [size=256] [virtual] Expansion ROM at 20400000 [disabled] [size=128K] Capabilities: [48] Power Management version 2 Capabilities: [50] Vital Product Data The happens in both Linux-2.6.26(skge version 1.23) and RHEL5.2(skge version 1.6). For example, at first it is set to "speed 1000 duplex full auto-neg on" and it works, then run ethtool -s <ethx> autoneg off or ethtool -s <ethx> speed 100 duplex full autoneg off Then it will stop working. After that if we restart the interface: ifconifg <ethx> down ifconfig <ethx> up It will work again. And `ethtool -A' has the same issue. So we think after setting the options, the interface should be restarted. Signed-off-by: Zhang Xiaoming <xiaoming.zhang@xxxxxxxxxxxxxx> Acked-by: Stephen Hemminger <shemminger@xxxxxxxxxx> Cc: Jeff Garzik <jeff@xxxxxxxxxx> On Tue, 23 Sep 2008 16:47:18 -0700 Stephen Hemminger <shemminger@xxxxxxxxxx> wrote: > Since skge_up can fail because of out of memory, this code needs to > check the return value. And then if it fails the "limbo state" needs > to be handled in skge_down. Signed-off-by: Andrew Morton <akpm@xxxxxxxxxxxxxxxxxxxx> --- drivers/net/skge.c | 12 ++++++++---- 1 file changed, 8 insertions(+), 4 deletions(-) diff -puN drivers/net/skge.c~driver-net-skgec-restart-the-interface-when-its-options-or-pauseparam-is-set drivers/net/skge.c --- a/drivers/net/skge.c~driver-net-skgec-restart-the-interface-when-its-options-or-pauseparam-is-set +++ a/drivers/net/skge.c @@ -367,8 +367,10 @@ static int skge_set_settings(struct net_ skge->autoneg = ecmd->autoneg; skge->advertising = ecmd->advertising; - if (netif_running(dev)) - skge_phy_reset(skge); + if (netif_running(dev)) { + skge_down(dev); + skge_up(dev); + } return (0); } @@ -609,8 +611,10 @@ static int skge_set_pauseparam(struct ne skge->flow_control = FLOW_MODE_NONE; } - if (netif_running(dev)) - skge_phy_reset(skge); + if (netif_running(dev)) { + skge_down(dev); + skge_up(dev); + } return 0; } _ Patches currently in -mm which might be from Xiaoming.Zhang@xxxxxxxxxxxxxx are git-net.patch -- To unsubscribe from this list: send the line "unsubscribe mm-commits" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html