The patch titled
Blackfin NFC Driver: add support for the ECC layout the Blackfin bootrom uses
has been added to the -mm tree. Its filename is
blackfin-nfc-driver-add-support-for-the-ecc-layout-the-blackfin-bootrom-uses.patch
Before you just go and hit "reply", please:
a) Consider who else should be cc'ed
b) Prefer to cc a suitable mailing list as well
c) Ideally: find the original patch on the mailing list and do a
reply-to-all to that, adding suitable additional cc's
*** Remember to use Documentation/SubmitChecklist when testing your code ***
See http://www.zip.com.au/~akpm/linux/patches/stuff/added-to-mm.txt to find
out what to do about this
The current -mm tree may be found at http://userweb.kernel.org/~akpm/mmotm/
------------------------------------------------------
Subject: Blackfin NFC Driver: add support for the ECC layout the Blackfin bootrom uses
From: Mike Frysinger <vapier.adi@xxxxxxxxx>
Signed-off-by: Mike Frysinger <vapier.adi@xxxxxxxxx>
Signed-off-by: Bryan Wu <cooloney@xxxxxxxxxx>
Signed-off-by: Andrew Morton <akpm@xxxxxxxxxxxxxxxxxxxx>
---
drivers/mtd/nand/Kconfig | 12 +++++++++
drivers/mtd/nand/bf5xx_nand.c | 40 ++++++++++++++++++++++++++++++++
2 files changed, 52 insertions(+)
diff -puN drivers/mtd/nand/Kconfig~blackfin-nfc-driver-add-support-for-the-ecc-layout-the-blackfin-bootrom-uses drivers/mtd/nand/Kconfig
--- a/drivers/mtd/nand/Kconfig~blackfin-nfc-driver-add-support-for-the-ecc-layout-the-blackfin-bootrom-uses
+++ a/drivers/mtd/nand/Kconfig
@@ -109,6 +109,18 @@ config MTD_NAND_BF5XX_HWECC
Enable the use of the BF5XX's internal ECC generator when
using NAND.
+config MTD_NAND_BF5XX_BOOTROM_ECC
+ bool "Use Blackfin BootROM ECC Layout"
+ default n
+ depends on MTD_NAND_BF5XX_HWECC
+ help
+ If you wish to modify NAND pages and allow the Blackfin on-chip
+ BootROM to boot from them, say Y here. This is only necessary
+ if you are booting U-Boot out of NAND and you wish to update
+ U-Boot from Linux' userspace. Otherwise, you should say N here.
+
+ If unsure, say N.
+
config MTD_NAND_RTC_FROM4
tristate "Renesas Flash ROM 4-slot interface board (FROM_BOARD4)"
depends on SH_SOLUTION_ENGINE
diff -puN drivers/mtd/nand/bf5xx_nand.c~blackfin-nfc-driver-add-support-for-the-ecc-layout-the-blackfin-bootrom-uses drivers/mtd/nand/bf5xx_nand.c
--- a/drivers/mtd/nand/bf5xx_nand.c~blackfin-nfc-driver-add-support-for-the-ecc-layout-the-blackfin-bootrom-uses
+++ a/drivers/mtd/nand/bf5xx_nand.c
@@ -91,6 +91,41 @@ static const unsigned short bfin_nfc_pin
P_NAND_ALE,
0};
+#ifdef CONFIG_MTD_NAND_BF5XX_BOOTROM_ECC
+static uint8_t bbt_pattern[] = { 0xff };
+
+static struct nand_bbt_descr bootrom_bbt = {
+ .options = 0,
+ .offs = 63,
+ .len = 1,
+ .pattern = bbt_pattern,
+};
+
+static struct nand_ecclayout bootrom_ecclayout = {
+ .eccbytes = 24,
+ .eccpos = {
+ 0x8 * 0, 0x8 * 0 + 1, 0x8 * 0 + 2,
+ 0x8 * 1, 0x8 * 1 + 1, 0x8 * 1 + 2,
+ 0x8 * 2, 0x8 * 2 + 1, 0x8 * 2 + 2,
+ 0x8 * 3, 0x8 * 3 + 1, 0x8 * 3 + 2,
+ 0x8 * 4, 0x8 * 4 + 1, 0x8 * 4 + 2,
+ 0x8 * 5, 0x8 * 5 + 1, 0x8 * 5 + 2,
+ 0x8 * 6, 0x8 * 6 + 1, 0x8 * 6 + 2,
+ 0x8 * 7, 0x8 * 7 + 1, 0x8 * 7 + 2
+ },
+ .oobfree = {
+ { 0x8 * 0 + 3, 5 },
+ { 0x8 * 1 + 3, 5 },
+ { 0x8 * 2 + 3, 5 },
+ { 0x8 * 3 + 3, 5 },
+ { 0x8 * 4 + 3, 5 },
+ { 0x8 * 5 + 3, 5 },
+ { 0x8 * 6 + 3, 5 },
+ { 0x8 * 7 + 3, 5 },
+ }
+};
+#endif
+
/*
* Data structures for bf5xx nand flash controller driver
*/
@@ -712,6 +747,11 @@ static int bf5xx_nand_probe(struct platf
/* setup hardware ECC data struct */
if (hardware_ecc) {
+#ifdef CONFIG_MTD_NAND_BF5XX_BOOTROM_ECC
+ chip->badblock_pattern = &bootrom_bbt;
+ chip->ecc.layout = &bootrom_ecclayout;
+#endif
+
if (plat->page_size == NFC_PG_SIZE_256) {
chip->ecc.bytes = 3;
chip->ecc.size = 256;
_
Patches currently in -mm which might be from vapier.adi@xxxxxxxxx are
blackfin-nfc-driver-fix-bug-do-not-clobber-the-status-from-the-first-256-bytes-if-operating-on-512-pages.patch
blackfin-nfc-driver-fix-bug-hw-ecc-calc-by-making-sure-we-extract-11-bits-from-each-register-instead-of-10.patch
blackfin-nfc-driver-add-support-for-the-ecc-layout-the-blackfin-bootrom-uses.patch
blackfin-nfc-driver-add-proper-devinit-devexit-markings-to-probe-remove-functions.patch
blackfin-nfc-driver-enable-blackfin-nand-hwecc-support-by-default.patch
blackfin-nfc-driver-use-standard-dev_err-rather-than-printk.patch
blackfin-nfc-driver-cleanup-the-error-exit-path-of-bf5xx_nand_probe-function.patch
--
To unsubscribe from this list: send the line "unsubscribe mm-commits" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
