The patch titled spi_bfin5xx: use PIO for full duplex, not DMA has been removed from the -mm tree. Its filename was spi_bfin5xx-use-pio-for-full-duplex-not-dma.patch This patch was dropped because it was merged into mainline or a subsystem tree The current -mm tree may be found at http://userweb.kernel.org/~akpm/mmotm/ ------------------------------------------------------ Subject: spi_bfin5xx: use PIO for full duplex, not DMA From: Vitja Makarov <vitja.makarov@xxxxxxxxx> Use PIO for full-duplex transfers, instead of DMA. Signed-off-by: Vitja Makarov <vitja.makarov@xxxxxxxxx> Signed-off-by: Bryan Wu <cooloney@xxxxxxxxxx> Signed-off-by: David Brownell <dbrownell@xxxxxxxxxxxxxxxxxxxxx> Signed-off-by: Andrew Morton <akpm@xxxxxxxxxxxxxxxxxxxx> --- drivers/spi/spi_bfin5xx.c | 7 +++++-- 1 file changed, 5 insertions(+), 2 deletions(-) diff -puN drivers/spi/spi_bfin5xx.c~spi_bfin5xx-use-pio-for-full-duplex-not-dma drivers/spi/spi_bfin5xx.c --- a/drivers/spi/spi_bfin5xx.c~spi_bfin5xx-use-pio-for-full-duplex-not-dma +++ a/drivers/spi/spi_bfin5xx.c @@ -608,6 +608,7 @@ static void pump_transfers(unsigned long u8 width; u16 cr, dma_width, dma_config; u32 tranf_success = 1; + u8 full_duplex = 0; /* Get current state information */ message = drv_data->cur_msg; @@ -658,6 +659,7 @@ static void pump_transfers(unsigned long } if (transfer->rx_buf != NULL) { + full_duplex = transfer->tx_buf != NULL; drv_data->rx = transfer->rx_buf; drv_data->rx_end = drv_data->rx + transfer->len; dev_dbg(&drv_data->pdev->dev, "rx_buf is %p, rx_end is %p\n", @@ -740,7 +742,8 @@ static void pump_transfers(unsigned long * successful use different way to r/w according to * drv_data->cur_chip->enable_dma */ - if (drv_data->cur_chip->enable_dma && drv_data->len > 6) { + if (!full_duplex && drv_data->cur_chip->enable_dma + && drv_data->len > 6) { disable_dma(drv_data->dma_channel); clear_dma_irqstat(drv_data->dma_channel); @@ -828,7 +831,7 @@ static void pump_transfers(unsigned long /* IO mode write then read */ dev_dbg(&drv_data->pdev->dev, "doing IO transfer\n"); - if (drv_data->tx != NULL && drv_data->rx != NULL) { + if (full_duplex) { /* full duplex mode */ BUG_ON((drv_data->tx_end - drv_data->tx) != (drv_data->rx_end - drv_data->rx)); _ Patches currently in -mm which might be from vitja.makarov@xxxxxxxxx are origin.patch -- To unsubscribe from this list: send the line "unsubscribe mm-commits" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html