The patch titled
sane irq initialization in sedlbauer/hisax
has been removed from the -mm tree. Its filename was
sane-irq-initialization-in-sedlbauer-hisax.patch
This patch was dropped because it was nacked
------------------------------------------------------
Subject: sane irq initialization in sedlbauer/hisax
From: Thomas Voegtle <tv@xxxxxxxx>
Thomas Voegtle wrote:
[...]
> <06>2007 May 30 14:21:40 cbs kern: Sedlbauer: PCI base adr 0xa800
> <03>2007 May 30 14:21:40 cbs kern: irq 11: nobody cared (try booting with the \"irqpoll\" option)
[...]
> <03>2007 May 30 14:21:40 cbs kern: handlers:
> <03>2007 May 30 14:21:40 cbs kern: [<c030899d>] (usb_hcd_irq+0x0/0x4f)
> <00>2007 May 30 14:21:40 cbs kern: Disabling IRQ #11
As described, the interrupt handler is registered too late, so early
incoming interrupts lead to the original problem. The patch first disables
the interrupts (byteout(..., 0)), then registers the irq, and finally
enables the irqs again (byteout(..., 2) as was done at the first point
before).
Please note that the patch was developed without access to technical
specifications; the /exact/ meaning of the constants being written to the
registers are unknown.
Signed-off-by: Bastian Friedrich <bastian@xxxxxxxxxxxxxxxxxxxx>
Signed-off-by: Thomas Voegtle <tv@xxxxxxxx>
Cc: Karsten Keil <kkeil@xxxxxxx>
Signed-off-by: Andrew Morton <akpm@xxxxxxxxxxxxxxxxxxxx>
---
drivers/isdn/hisax/config.c | 2 ++
drivers/isdn/hisax/sedlbauer.c | 16 +++++++++++++++-
2 files changed, 17 insertions(+), 1 deletion(-)
diff -puN drivers/isdn/hisax/config.c~sane-irq-initialization-in-sedlbauer-hisax drivers/isdn/hisax/config.c
--- a/drivers/isdn/hisax/config.c~sane-irq-initialization-in-sedlbauer-hisax
+++ a/drivers/isdn/hisax/config.c
@@ -511,6 +511,7 @@ extern int setup_TeleInt(struct IsdnCard
#if CARD_SEDLBAUER
extern int setup_sedlbauer(struct IsdnCard *card);
+extern void sedlbauer_enable_interrupts(struct IsdnCardState *cs);
#endif
#if CARD_SPORTSTER
@@ -822,6 +823,7 @@ static int init_card(struct IsdnCardStat
cs->irq);
return 1;
}
+ sedlbauer_enable_interrupts(cs);
while (cnt) {
cs->cardmsg(cs, CARD_INIT, NULL);
/* Timeout 10ms */
diff -puN drivers/isdn/hisax/sedlbauer.c~sane-irq-initialization-in-sedlbauer-hisax drivers/isdn/hisax/sedlbauer.c
--- a/drivers/isdn/hisax/sedlbauer.c~sane-irq-initialization-in-sedlbauer-hisax
+++ a/drivers/isdn/hisax/sedlbauer.c
@@ -529,6 +529,19 @@ static struct isapnp_device_id *ipid __d
static struct pnp_card *pnp_c __devinitdata = NULL;
#endif
+int
+sedlbauer_enable_interrupts(struct IsdnCardState *cs)
+{
+#ifdef CONFIG_PCI
+ if ((cs->typ == ISDN_CTYPE_SEDLBAUER) ||
+ (cs->typ == ISDN_CTYPE_SEDLBAUER_FAX)) {
+ byteout(cs->hw.sedl.cfg_reg+ 5, 0x02);
+ }
+#endif
+ return 0;
+}
+
+
int __devinit
setup_sedlbauer(struct IsdnCard *card)
{
@@ -667,7 +680,8 @@ setup_sedlbauer(struct IsdnCard *card)
byteout(cs->hw.sedl.cfg_reg, 0xff);
byteout(cs->hw.sedl.cfg_reg, 0x00);
byteout(cs->hw.sedl.cfg_reg+ 2, 0xdd);
- byteout(cs->hw.sedl.cfg_reg+ 5, 0x02);
+ byteout(cs->hw.sedl.cfg_reg+ 5, 0x00);
+ /* 0 seems to be "disable". Enable (-> 0x02) later! */
byteout(cs->hw.sedl.cfg_reg +3, cs->hw.sedl.reset_on);
mdelay(2);
byteout(cs->hw.sedl.cfg_reg +3, cs->hw.sedl.reset_off);
_
Patches currently in -mm which might be from tv@xxxxxxxx are
sane-irq-initialization-in-sedlbauer-hisax.patch
-
To unsubscribe from this list: send the line "unsubscribe mm-commits" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
