- ide-backport-piix-fixes-from-libata-into-the-legacy-driver.patch removed from -mm tree

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



The patch titled

     ide: backport piix fixes from libata into the legacy driver

has been removed from the -mm tree.  Its filename is

     ide-backport-piix-fixes-from-libata-into-the-legacy-driver.patch

This patch was dropped because it was merged into mainline or a subsystem tree

------------------------------------------------------
Subject: ide: backport piix fixes from libata into the legacy driver
From: Alan Cox <alan@xxxxxxxxxxxxxxxxxxx>

There are three flags being set by default by the PIIX driver for speeds >
PIO 1, and one not being cleared properly on fallback to PIO0.  The most
important one is the prefetch/post write control which only works for ATA
and can do bad things with ATAPI.

The patch does its best to set the flags correctly for drivers/ide.  Its
not 100% perfect but its closer than the original.  100% perfect requires
proper IORDY handling but this isn't critical (and its not right in libata
either ..  yet)


Sergei Shtylyov <sshtylyov@xxxxxxxxxxxxx> said:

> +					{ 0, 0 },
> +					{ 0, 0 },
> +					{ 1, 0 },
> +					{ 2, 1 },
> +					{ 2, 3 }, };
>  
>  	pio = ide_get_best_pio_mode(drive, pio, 5, NULL);

    BTW, there's quite obvious error here which leads to access outside of 
timings[] if somebody passes PIO mode 5 (or autotuning code finds out that 
drive supports PIO mode 5). Could have been fixed while at it... Those drives 
should be rare, though...

> +		}
>  		master_data = master_data | (timings[pio][0] << 12) | (timings[pio][1] << 8);
>  	}
>  	pci_write_config_word(dev, master_port, master_data);

    Actually, there's one more serious issue with piix_tune_drive() -- it 
doesn't actually set the drive's own transfer mode.

Signed-off-by: Alan Cox <alan@xxxxxxxxxx>
Cc: Sergei Shtylyov <sshtylyov@xxxxxxxxxxxxx>
Cc: Bartlomiej Zolnierkiewicz <B.Zolnierkiewicz@xxxxxxxxxxxxxx>
Signed-off-by: Andrew Morton <akpm@xxxxxxxx>
---

 drivers/ide/pci/piix.c |   31 ++++++++++++++++++++++---------
 1 file changed, 22 insertions(+), 9 deletions(-)

diff -puN drivers/ide/pci/piix.c~ide-backport-piix-fixes-from-libata-into-the-legacy-driver drivers/ide/pci/piix.c
--- a/drivers/ide/pci/piix.c~ide-backport-piix-fixes-from-libata-into-the-legacy-driver
+++ a/drivers/ide/pci/piix.c
@@ -222,13 +222,15 @@ static void piix_tune_drive (ide_drive_t
 	u16 master_data;
 	u8 slave_data;
 	static DEFINE_SPINLOCK(tune_lock);
+	int control = 0;
 
 				 /* ISP  RTC */
-	u8 timings[][2]	= { { 0, 0 },
-			    { 0, 0 },
-			    { 1, 0 },
-			    { 2, 1 },
-			    { 2, 3 }, };
+	static const u8 timings[][2]= {
+					{ 0, 0 },
+					{ 0, 0 },
+					{ 1, 0 },
+					{ 2, 1 },
+					{ 2, 3 }, };
 
 	pio = ide_get_best_pio_mode(drive, pio, 5, NULL);
 
@@ -239,19 +241,30 @@ static void piix_tune_drive (ide_drive_t
 	 */
 	spin_lock_irqsave(&tune_lock, flags);
 	pci_read_config_word(dev, master_port, &master_data);
+
+	if (pio >= 2)
+		control |= 1;	/* Programmable timing on */
+	if (drive->media == ide_disk)
+		control |= 4;	/* Prefetch, post write */
+	if (pio >= 3)
+		control |= 2;	/* IORDY */
 	if (is_slave) {
 		master_data = master_data | 0x4000;
-		if (pio > 1)
+		if (pio > 1) {
 			/* enable PPE, IE and TIME */
-			master_data = master_data | 0x0070;
+			master_data = master_data | (control << 4);
+		} else {
+			master_data &= ~0x0070;
+		}
 		pci_read_config_byte(dev, slave_port, &slave_data);
 		slave_data = slave_data & (hwif->channel ? 0x0f : 0xf0);
 		slave_data = slave_data | (((timings[pio][0] << 2) | timings[pio][1]) << (hwif->channel ? 4 : 0));
 	} else {
 		master_data = master_data & 0xccf8;
-		if (pio > 1)
+		if (pio > 1) {
 			/* enable PPE, IE and TIME */
-			master_data = master_data | 0x0007;
+			master_data = master_data | control;
+		}
 		master_data = master_data | (timings[pio][0] << 12) | (timings[pio][1] << 8);
 	}
 	pci_write_config_word(dev, master_port, master_data);
_

Patches currently in -mm which might be from alan@xxxxxxxxxxxxxxxxxxx are

origin.patch
fix-gregkh-driver-nozomi.patch
git-dvb.patch
libata-add-40pin-short-cable-support-honour-drive.patch
pci_module_init-convertion-in-ata_genericc.patch
pci_module_init-convertion-in-ata_genericc-fix.patch
via-pata-controller-xfer-fixes.patch
ahci-ati-sb600-sata-support-for-various-modes.patch
quirks-switch-quirks-code-offender-to-use-pci_get-api.patch
git-scsi-misc.patch
ioremap-balanced-with-iounmap-drivers-scsi-ncr53c8xxc.patch
edac-new-opteron-athlon64-memory-controller-driver.patch
edac-new-opteron-athlon64-memory-controller-driver-tidy.patch
pci-mxser-pci-refcounts.patch
mxser-make-an-experimental-clone.patch
char-mxser_new-correct-include-file.patch
char-mxser_new-upgrade-to-191.patch
char-mxser_new-rework-to-allow-dynamic-structs.patch
ide-hpt3xxn-clocking-fixes.patch
ide-fix-hpt37x-timing-tables.patch
ide-optimize-hpt37x-timing-tables.patch
ide-fix-hpt3xx-hotswap-support.patch
ide-fix-the-case-of-multiple-hpt3xx-chips-present.patch
ide-hpt3xx-fix-pci-clock-detection.patch
ide-hpt3xx-fix-pci-clock-detection-fix-2.patch
piix-fix-82371mx-enablebits.patch
piix-remove-check-for-broken-mw-dma-mode-0.patch
piix-slc90e66-pio-mode-fallback-fix.patch
hpt3xx-rework-rate-filtering.patch
hpt3xx-rework-rate-filtering-tidy.patch
hpt3xx-print-the-real-chip-name-at-startup.patch
hpt3xx-switch-to-using-pci_get_slot.patch
hpt3xx-cache-channels-mcr-address.patch
hpt3x7-merge-speedproc-handlers.patch
hpt370-clean-up-dma-timeout-handling.patch
hpt3xx-init-code-rewrite.patch
ide-more-conversion-to-pci_get-apis.patch

-
To unsubscribe from this list: send the line "unsubscribe mm-commits" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html

[Index of Archives]     [Kernel Newbies FAQ]     [Kernel Archive]     [IETF Annouce]     [DCCP]     [Netdev]     [Networking]     [Security]     [Bugtraq]     [Photo]     [Yosemite]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux SCSI]

  Powered by Linux