- ide-clean-up-pdc202xx_old-so-its-more-readable-done-so-i-could-work-on-libata-ports.patch removed from -mm tree

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



The patch titled

     ide: clean up pdc202xx_old so its more readable (done so I could work on libata ports)

has been removed from the -mm tree.  Its filename is

     ide-clean-up-pdc202xx_old-so-its-more-readable-done-so-i-could-work-on-libata-ports.patch

This patch was dropped because it was merged into mainline or a subsystem tree

------------------------------------------------------
Subject: ide: clean up pdc202xx_old so its more readable (done so I could work on libata ports)
From: Alan Cox <alan@xxxxxxxxxxxxxxxxxxx>

Also sets the new fifo flag so that we don't hang on some errors with this
chipset.

Signed-off-by: Alan Cox <alan@xxxxxxxxxx>
Cc: Bartlomiej Zolnierkiewicz <B.Zolnierkiewicz@xxxxxxxxxxxxxx>
Cc: Sergei Shtylyov <sshtylyov@xxxxxxxxxxxxx>
Signed-off-by: Andrew Morton <akpm@xxxxxxxx>
---

 drivers/ide/pci/pdc202xx_old.c |  115 +------------------------------
 1 file changed, 5 insertions(+), 110 deletions(-)

diff -puN drivers/ide/pci/pdc202xx_old.c~ide-clean-up-pdc202xx_old-so-its-more-readable-done-so-i-could-work-on-libata-ports drivers/ide/pci/pdc202xx_old.c
--- a/drivers/ide/pci/pdc202xx_old.c~ide-clean-up-pdc202xx_old-so-its-more-readable-done-so-i-could-work-on-libata-ports
+++ a/drivers/ide/pci/pdc202xx_old.c
@@ -101,31 +101,6 @@ static const char *pdc_quirk_drives[] = 
 #define	MC1		0x02	/* DMA"C" timing */
 #define	MC0		0x01	/* DMA"C" timing */
 
-#if 0
-	unsigned long bibma  = pci_resource_start(dev, 4);
-	u8 hi = 0, lo = 0;
-
-	u8 sc1c	= inb_p((u16)bibma + 0x1c); 
-	u8 sc1e	= inb_p((u16)bibma + 0x1e);
-	u8 sc1f	= inb_p((u16)bibma + 0x1f);
-
-	p += sprintf(p, "Host Mode                            : %s\n",
-		(sc1f & 0x08) ? "Tri-Stated" : "Normal");
-	p += sprintf(p, "Bus Clocking                         : %s\n",
-		((sc1f & 0xC0) == 0xC0) ? "100 External" :
-		((sc1f & 0x80) == 0x80) ? "66 External" :
-		((sc1f & 0x40) == 0x40) ? "33 External" : "33 PCI Internal");
-	p += sprintf(p, "IO pad select                        : %s mA\n",
-		((sc1c & 0x03) == 0x03) ? "10" :
-		((sc1c & 0x02) == 0x02) ? "8" :
-		((sc1c & 0x01) == 0x01) ? "6" :
-		((sc1c & 0x00) == 0x00) ? "4" : "??");
-	hi = sc1e >> 4;
-	lo = sc1e & 0xf;
-	p += sprintf(p, "Status Polling Period                : %d\n", hi);
-	p += sprintf(p, "Interrupt Check Status Polling Delay : %d\n", lo);
-#endif
-
 static u8 pdc202xx_ratemask (ide_drive_t *drive)
 {
 	u8 mode;
@@ -505,42 +480,13 @@ static void pdc202xx_reset (ide_drive_t 
 	
 	pdc202xx_reset_host(hwif);
 	pdc202xx_reset_host(mate);
-#if 0
-	/*
-	 * FIXME: Have to kick all the drives again :-/
-	 * What a pain in the ACE!
-	 */
-	if (hwif->present) {
-		u16 hunit = 0;
-		for (hunit = 0; hunit < MAX_DRIVES; ++hunit) {
-			ide_drive_t *hdrive = &hwif->drives[hunit];
-			if (hdrive->present) {
-				if (hwif->ide_dma_check)
-					hwif->ide_dma_check(hdrive);
-				else
-					hwif->tuneproc(hdrive, 5);
-			}
-		}
-	}
-	if (mate->present) {
-		u16 munit = 0;
-		for (munit = 0; munit < MAX_DRIVES; ++munit) {
-			ide_drive_t *mdrive = &mate->drives[munit];
-			if (mdrive->present) {
-				if (mate->ide_dma_check) 
-					mate->ide_dma_check(mdrive);
-				else
-					mate->tuneproc(mdrive, 5);
-			}
-		}
-	}
-#else
 	hwif->tuneproc(drive, 5);
-#endif
 }
 
-static unsigned int __devinit init_chipset_pdc202xx(struct pci_dev *dev, const char *name)
+static unsigned int __devinit init_chipset_pdc202xx(struct pci_dev *dev,
+							const char *name)
 {
+	/* This doesn't appear needed */
 	if (dev->resource[PCI_ROM_RESOURCE].start) {
 		pci_write_config_dword(dev, PCI_ROM_ADDRESS,
 			dev->resource[PCI_ROM_RESOURCE].start | PCI_ROM_ADDRESS_ENABLE);
@@ -548,30 +494,6 @@ static unsigned int __devinit init_chips
 			name, dev->resource[PCI_ROM_RESOURCE].start);
 	}
 
-	/*
-	 * software reset -  this is required because the bios
-	 * will set UDMA timing on if the hdd supports it. The
-	 * user may want to turn udma off. A bug in the pdc20262
-	 * is that it cannot handle a downgrade in timing from
-	 * UDMA to DMA. Disk accesses after issuing a set
-	 * feature command will result in errors. A software
-	 * reset leaves the timing registers intact,
-	 * but resets the drives.
-	 */
-#if 0
-	if ((dev->device == PCI_DEVICE_ID_PROMISE_20267) ||
-	    (dev->device == PCI_DEVICE_ID_PROMISE_20265) ||
-	    (dev->device == PCI_DEVICE_ID_PROMISE_20263) ||
-	    (dev->device == PCI_DEVICE_ID_PROMISE_20262)) {
-		unsigned long high_16	= pci_resource_start(dev, 4);
-		byte udma_speed_flag	= inb(high_16 + 0x001f);
-		outb(udma_speed_flag | 0x10, high_16 + 0x001f);
-		mdelay(100);
-		outb(udma_speed_flag & ~0x10, high_16 + 0x001f);
-		mdelay(2000);	/* 2 seconds ?! */
-	}
-
-#endif
 	return dev->irq;
 }
 
@@ -599,6 +521,8 @@ static void __devinit init_hwif_pdc202xx
 	hwif->mwdma_mask = 0x07;
 	hwif->swdma_mask = 0x07;
 
+	hwif->err_stops_fifo = 1;
+
 	hwif->ide_dma_check = &pdc202xx_config_drive_xfer_rate;
 	hwif->ide_dma_lostirq = &pdc202xx_ide_dma_lostirq;
 	hwif->ide_dma_timeout = &pdc202xx_ide_dma_timeout;
@@ -687,19 +611,6 @@ static int __devinit init_setup_pdc202at
 				"mirror fixed.\n", d->name);
 		}
 	}
-
-#if 0
-        if (dev->device == PCI_DEVICE_ID_PROMISE_20262)
-        if (e->reg && (pci_read_config_byte(dev, e->reg, &tmp) ||
-             (tmp & e->mask) != e->val))
-
-        if (d->enablebits[0].reg != d->enablebits[1].reg) {
-                d->enablebits[0].reg    = d->enablebits[1].reg;
-                d->enablebits[0].mask   = d->enablebits[1].mask;
-                d->enablebits[0].val    = d->enablebits[1].val;
-        }
-#endif
-
 	return ide_setup_pci_device(dev, d);
 }
 
@@ -714,22 +625,6 @@ static int __devinit init_setup_pdc20265
 			"attached to I2O RAID controller.\n");
 		return -ENODEV;
 	}
-
-#if 0
-        {
-                u8 pri = 0, sec = 0;
-
-        if (e->reg && (pci_read_config_byte(dev, e->reg, &tmp) ||
-             (tmp & e->mask) != e->val))
-
-        if (d->enablebits[0].reg != d->enablebits[1].reg) {
-                d->enablebits[0].reg    = d->enablebits[1].reg;
-                d->enablebits[0].mask   = d->enablebits[1].mask;
-                d->enablebits[0].val    = d->enablebits[1].val;
-        }
-        }
-#endif
-
 	return ide_setup_pci_device(dev, d);
 }
 
_

Patches currently in -mm which might be from alan@xxxxxxxxxxxxxxxxxxx are

origin.patch
via-pata-controller-xfer-fixes.patch
git-pcmcia.patch
git-scsi-misc.patch
megaraid-gcc-41-warning-fix.patch
edac-pci-device-to-device-cleanup.patch
edac-mc-numbers-refactor-1-of-2.patch
edac-mc-numbers-refactor-2-of-2.patch
edac-probe1-cleanup-1-of-2.patch
edac-probe1-cleanup-2-of-2.patch
edac-maintainers-update.patch
ide-claim-extra-dma-ports-regardless-of-channel.patch
ide-always-release-dma-engine.patch
ide-error-handling-fixes.patch
ide-hpt3xxn-clocking-fixes.patch
ide-fix-hpt37x-timing-tables.patch
ide-optimize-hpt37x-timing-tables.patch
ide-fix-hpt3xx-hotswap-support.patch
ide-fix-the-case-of-multiple-hpt3xx-chips-present.patch
ide-hpt3xx-fix-pci-clock-detection.patch
ide-hpt3xx-fix-pci-clock-detection-fix-2.patch
piix-fix-82371mx-enablebits.patch
piix-remove-check-for-broken-mw-dma-mode-0.patch
piix-slc90e66-pio-mode-fallback-fix.patch
make-number-of-ide-interfaces-configurable.patch
ide_dma_speed-fixes.patch
hpt3xx-rework-rate-filtering.patch
hpt3xx-rework-rate-filtering-tidy.patch
hpt3xx-print-the-real-chip-name-at-startup.patch
hpt3xx-switch-to-using-pci_get_slot.patch
hpt3xx-cache-channels-mcr-address.patch
hpt3x7-merge-speedproc-handlers.patch
hpt370-clean-up-dma-timeout-handling.patch
enable-cdrom-dma-access-with-pdc20265_old.patch
ide-fix-revision-comparison-in-ide_in_drive_list.patch
drivers-ide-legacy-ide-csc-make-2-functions-static.patch
ide-backport-piix-fixes-from-libata-into-the-legacy-driver.patch
hpt3xx-init-code-rewrite.patch
revert-tty-buffering-comment-out-debug-code.patch

-
To unsubscribe from this list: send the line "unsubscribe mm-commits" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html

[Index of Archives]     [Kernel Newbies FAQ]     [Kernel Archive]     [IETF Annouce]     [DCCP]     [Netdev]     [Networking]     [Security]     [Bugtraq]     [Photo]     [Yosemite]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux SCSI]

  Powered by Linux