The patch titled
ide: clean up siimage
has been removed from the -mm tree. Its filename is
ide-clean-up-siimage.patch
This patch was dropped because it was merged into mainline or a subsystem tree
------------------------------------------------------
Subject: ide: clean up siimage
From: Alan Cox <alan@xxxxxxxxxxxxxxxxxxx>
Remove all the ifdef preparation for enhanced features that never occcurred
and is only in libata. For the SATA chips (but not yet PATA ones) politely
suggest to the user that libata may offer more features.
Signed-off-by: Alan Cox <alan@xxxxxxxxxx>
Cc: Sergei Shtylylov <sshtylyov@xxxxxxxxxxxxx>
Signed-off-by: Andrew Morton <akpm@xxxxxxxx>
---
drivers/ide/pci/siimage.c | 62 ++++++------------------------------
1 file changed, 12 insertions(+), 50 deletions(-)
diff -puN drivers/ide/pci/siimage.c~ide-clean-up-siimage drivers/ide/pci/siimage.c
--- a/drivers/ide/pci/siimage.c~ide-clean-up-siimage
+++ a/drivers/ide/pci/siimage.c
@@ -38,9 +38,6 @@
#include <asm/io.h>
-#undef SIIMAGE_VIRTUAL_DMAPIO
-#undef SIIMAGE_LARGE_DMA
-
/**
* pdev_is_sata - check if device is SATA
* @pdev: PCI device to check
@@ -461,36 +458,6 @@ static int siimage_io_ide_dma_test_irq (
return 0;
}
-#if 0
-/**
- * siimage_mmio_ide_dma_count - DMA bytes done
- * @drive
- *
- * If we are doing VDMA the CMD680 requires a little bit
- * of more careful handling and we have to read the counts
- * off ourselves. For non VDMA life is normal.
- */
-
-static int siimage_mmio_ide_dma_count (ide_drive_t *drive)
-{
-#ifdef SIIMAGE_VIRTUAL_DMAPIO
- struct request *rq = HWGROUP(drive)->rq;
- ide_hwif_t *hwif = HWIF(drive);
- u32 count = (rq->nr_sectors * SECTOR_SIZE);
- u32 rcount = 0;
- unsigned long addr = siimage_selreg(hwif, 0x1C);
-
- hwif->OUTL(count, addr);
- rcount = hwif->INL(addr);
-
- printk("\n%s: count = %d, rcount = %d, nr_sectors = %lu\n",
- drive->name, count, rcount, rq->nr_sectors);
-
-#endif /* SIIMAGE_VIRTUAL_DMAPIO */
- return __ide_dma_count(drive);
-}
-#endif
-
/**
* siimage_mmio_ide_dma_test_irq - check we caused an IRQ
* @drive: drive we are testing
@@ -512,12 +479,10 @@ static int siimage_mmio_ide_dma_test_irq
u32 sata_error = hwif->INL(SATA_ERROR_REG);
hwif->OUTL(sata_error, SATA_ERROR_REG);
watchdog = (sata_error & 0x00680000) ? 1 : 0;
-#if 1
printk(KERN_WARNING "%s: sata_error = 0x%08x, "
"watchdog = %d, %s\n",
drive->name, sata_error, watchdog,
__FUNCTION__);
-#endif
} else {
watchdog = (ext_stat & 0x8000) ? 1 : 0;
@@ -863,7 +828,7 @@ static unsigned int __devinit init_chips
* time.
*
* The hardware supports buffered taskfiles and also some rather nice
- * extended PRD tables. Unfortunately right now we don't.
+ * extended PRD tables. For better SI3112 support use the libata driver
*/
static void __devinit init_mmio_iops_siimage(ide_hwif_t *hwif)
@@ -900,9 +865,6 @@ static void __devinit init_mmio_iops_sii
* so we can't currently use it sanely since we want to
* use LBA48 mode.
*/
-// base += 0x10;
-// hwif->no_lba48 = 1;
-
hw.io_ports[IDE_DATA_OFFSET] = base;
hw.io_ports[IDE_ERROR_OFFSET] = base + 1;
hw.io_ports[IDE_NSECTOR_OFFSET] = base + 2;
@@ -936,15 +898,8 @@ static void __devinit init_mmio_iops_sii
base = (unsigned long) addr;
-#ifdef SIIMAGE_LARGE_DMA
-/* Watch the brackets - even Ken and Dennis get some language design wrong */
- hwif->dma_base = base + (ch ? 0x18 : 0x10);
- hwif->dma_base2 = base + (ch ? 0x08 : 0x00);
- hwif->dma_prdtable = hwif->dma_base2 + 4;
-#else /* ! SIIMAGE_LARGE_DMA */
hwif->dma_base = base + (ch ? 0x08 : 0x00);
hwif->dma_base2 = base + (ch ? 0x18 : 0x10);
-#endif /* SIIMAGE_LARGE_DMA */
hwif->mmio = 2;
}
@@ -1052,9 +1007,16 @@ static void __devinit init_hwif_siimage(
hwif->reset_poll = &siimage_reset_poll;
hwif->pre_reset = &siimage_pre_reset;
- if(is_sata(hwif))
+ if(is_sata(hwif)) {
+ static int first = 1;
+
hwif->busproc = &siimage_busproc;
+ if (first) {
+ printk(KERN_INFO "siimage: For full SATA support you should use the libata sata_sil module.\n");
+ first = 0;
+ }
+ }
if (!hwif->dma_base) {
hwif->drives[0].autotune = 1;
hwif->drives[1].autotune = 1;
@@ -1121,10 +1083,10 @@ static int __devinit siimage_init_one(st
}
static struct pci_device_id siimage_pci_tbl[] = {
- { PCI_VENDOR_ID_CMD, PCI_DEVICE_ID_SII_680, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0},
+ { PCI_DEVICE(PCI_VENDOR_ID_CMD, PCI_DEVICE_ID_SII_680), 0},
#ifdef CONFIG_BLK_DEV_IDE_SATA
- { PCI_VENDOR_ID_CMD, PCI_DEVICE_ID_SII_3112, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 1},
- { PCI_VENDOR_ID_CMD, PCI_DEVICE_ID_SII_1210SA, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 2},
+ { PCI_DEVICE(PCI_VENDOR_ID_CMD, PCI_DEVICE_ID_SII_3112), 1},
+ { PCI_DEVICE(PCI_VENDOR_ID_CMD, PCI_DEVICE_ID_SII_1210SA), 2},
#endif
{ 0, },
};
_
Patches currently in -mm which might be from alan@xxxxxxxxxxxxxxxxxxx are
origin.patch
via-pata-controller-xfer-fixes.patch
git-pcmcia.patch
git-scsi-misc.patch
megaraid-gcc-41-warning-fix.patch
edac-pci-device-to-device-cleanup.patch
edac-mc-numbers-refactor-1-of-2.patch
edac-mc-numbers-refactor-2-of-2.patch
edac-probe1-cleanup-1-of-2.patch
edac-probe1-cleanup-2-of-2.patch
edac-maintainers-update.patch
ide-claim-extra-dma-ports-regardless-of-channel.patch
ide-always-release-dma-engine.patch
ide-error-handling-fixes.patch
ide-hpt3xxn-clocking-fixes.patch
ide-fix-hpt37x-timing-tables.patch
ide-optimize-hpt37x-timing-tables.patch
ide-fix-hpt3xx-hotswap-support.patch
ide-fix-the-case-of-multiple-hpt3xx-chips-present.patch
ide-hpt3xx-fix-pci-clock-detection.patch
ide-hpt3xx-fix-pci-clock-detection-fix-2.patch
piix-fix-82371mx-enablebits.patch
piix-remove-check-for-broken-mw-dma-mode-0.patch
piix-slc90e66-pio-mode-fallback-fix.patch
make-number-of-ide-interfaces-configurable.patch
ide_dma_speed-fixes.patch
hpt3xx-rework-rate-filtering.patch
hpt3xx-rework-rate-filtering-tidy.patch
hpt3xx-print-the-real-chip-name-at-startup.patch
hpt3xx-switch-to-using-pci_get_slot.patch
hpt3xx-cache-channels-mcr-address.patch
hpt3x7-merge-speedproc-handlers.patch
hpt370-clean-up-dma-timeout-handling.patch
enable-cdrom-dma-access-with-pdc20265_old.patch
ide-fix-revision-comparison-in-ide_in_drive_list.patch
drivers-ide-legacy-ide-csc-make-2-functions-static.patch
ide-backport-piix-fixes-from-libata-into-the-legacy-driver.patch
hpt3xx-init-code-rewrite.patch
revert-tty-buffering-comment-out-debug-code.patch
-
To unsubscribe from this list: send the line "unsubscribe mm-commits" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
