The patch titled
ide: HPT3xx: fix PCI clock detection
has been added to the -mm tree. Its filename is
ide-hpt3xx-fix-pci-clock-detection.patch
See http://www.zip.com.au/~akpm/linux/patches/stuff/added-to-mm.txt to find
out what to do about this
From: Sergei Shtylyov <sshtylyov@xxxxxxxxxxxxx>
Use the f_CNT value saved by the HighPoint BIOS if available as reading it
directly would give us a wrong PCI frequency after DPLL has already been
calibrated by BIOS.
Signed-off-by: Sergei Shtylyov <sshtylyov@xxxxxxxxxxxxx>
Cc: Bartlomiej Zolnierkiewicz <B.Zolnierkiewicz@xxxxxxxxxxxxxx>
Cc: Alan Cox <alan@xxxxxxxxxxxxxxxxxxx>
Signed-off-by: Andrew Morton <akpm@xxxxxxxx>
---
drivers/ide/pci/hpt366.c | 46 +++++++++++++++++++++++++------------
1 files changed, 32 insertions(+), 14 deletions(-)
diff -puN drivers/ide/pci/hpt366.c~ide-hpt3xx-fix-pci-clock-detection drivers/ide/pci/hpt366.c
--- 25/drivers/ide/pci/hpt366.c~ide-hpt3xx-fix-pci-clock-detection Tue May 9 12:15:50 2006
+++ 25-akpm/drivers/ide/pci/hpt366.c Tue May 9 12:15:50 2006
@@ -70,6 +70,8 @@
* - fix/remove bad/unused timing tables and use one set of tables for the whole
* HPT37x chip family; save space by introducing the separate transfer mode
* table in which the mode lookup is done
+ * - use f_CNT value saved by the HighPoint BIOS as reading it directly gives
+ * the wrong PCI frequency since DPLL has already been calibrated by BIOS
* - fix the hotswap code: it caused RESET- to glitch when tristating the bus,
* and for HPT36x the obsolete HDIO_TRISTATE_HWIF handler was called instead
* - pass to init_chipset() handlers a copy of the IDE PCI device structure as
@@ -1011,8 +1013,8 @@ static void __devinit hpt37x_clocking(id
struct hpt_info *info = ide_get_hwifdata(hwif);
struct pci_dev *dev = hwif->pci_dev;
int adjust, i;
- u16 freq;
- u32 pll;
+ u16 freq = 0;
+ u32 pll, temp = 0;
u8 reg5bh = 0, mcr1 = 0;
/*
@@ -1026,15 +1028,34 @@ static void __devinit hpt37x_clocking(id
pci_write_config_byte(dev, 0x5b, 0x23);
/*
- * set up the PLL. we need to adjust it so that it's stable.
- * freq = Tpll * 192 / Tpci
+ * We'll have to read f_CNT value in order to determine
+ * the PCI clock frequency according to the following ratio:
*
- * Todo. For non x86 should probably check the dword is
- * set to 0xABCDExxx indicating the BIOS saved f_CNT
+ * f_CNT = Fpci * 192 / Fdpll
+ *
+ * First try reading the register in which the HighPoint BIOS
+ * saves f_CNT value before reprogramming the DPLL from its
+ * default setting (which differs for the various chips).
+ * In case the signature check fails, we'll have to resort to
+ * reading the f_CNT register itself in hopes that nobody has
+ * touched the DPLL yet...
*/
- pci_read_config_word(dev, 0x78, &freq);
- freq &= 0x1FF;
-
+ pci_read_config_dword(dev, 0x70, &temp);
+ if ((temp & 0xFFFFF000) != 0xABCDE000) {
+ int i;
+
+ printk(KERN_WARNING "HPT37X: no clock data saved by BIOS\n");
+
+ /* Calculate the average value of f_CNT */
+ for (temp = i = 0; i < 128; i++) {
+ pci_read_config_word(dev, 0x78, &freq);
+ temp += freq & 0x1ff;
+ mdelay(1);
+ }
+ freq = temp / 128;
+ } else
+ freq = temp & 0x1ff;
+
/*
* HPT3xxN chips use different PCI clock information.
* Currently we always set up the PLL for them.
@@ -1096,11 +1117,8 @@ static void __devinit hpt37x_clocking(id
info->flags |= PLL_MODE;
/*
- * FIXME: make this work correctly, esp with 372N as per
- * reference driver code.
- *
- * adjust PLL based upon PCI clock, enable it, and wait for
- * stabilization.
+ * Adjust the PLL based upon the PCI clock, enable it, and
+ * wait for stabilization...
*/
adjust = 0;
freq = (pll < F_LOW_PCI_50) ? 2 : 4;
_
Patches currently in -mm which might be from sshtylyov@xxxxxxxxxxxxx are
git-netdev-all.patch
git-serial.patch
ide-claim-extra-dma-ports-regardless-of-channel.patch
ide-remove-dma_base2-field-form-ide_hwif_t.patch
ide-always-release-dma-engine.patch
ide-hpt3xxn-clocking-fixes.patch
ide-actually-honor-drives-minimum-pio-dma-cycle-times.patch
ide-fix-hpt37x-timing-tables.patch
ide-optimize-hpt37x-timing-tables.patch
ide-fix-hpt3xx-hotswap-support.patch
ide-fix-the-case-of-multiple-hpt3xx-chips-present.patch
ide-hpt3xx-fix-pci-clock-detection.patch
ide-pdc202xx_old-remove-the-obsolete-busproc.patch
-
To unsubscribe from this list: send the line "unsubscribe mm-commits" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
