On 29/03/2018 at 16:40:41 +0200, Andrew Lunn wrote:
> > > > + for (i = 0; i < PHY_MAX_ADDR; i++) {
> > > > + if (mscc_miim_read(bus, i, MII_PHYSID1) < 0)
> > > > + bus->phy_mask |= BIT(i);
> > > > + }
> > >
> > > Why do this? Especially so for the external bus, where the PHYs might
> > > have a GPIO reset line, and won't respond until the gpio is
> > > released. The core code does that just before it scans the bus, or
> > > just before it scans the particular address on the bus, depending on
> > > the scope of the GPIO.
> > >
> >
> > IIRC, this was needed when probing the bus without DT, in that case, the
> > mdiobus_scan loop of __mdiobus_register() will fail when doing the
> > get_phy_id for phys 0 to 31 because get_phy_id() transforms any error in
> > -EIO and so it is impossible to register the bus. Other drivers have a
> > similar code to handle that case.
>
> Hi Alexandre
>
> Do you mean mscc_miim_read() will return -EIO if there is no device on
> the bus at the address trying to be read? Most devices just return
> 0xffff because there is a pull up on the data line, nothing is driving
> it, so all 1's are read.
>
It will return -EIO but I tried to be clever and return -ENODEV but this
gets changed to -EIO by get_phy_id.
> It sounds like the correct fix is for get_phy_id() to look at the
> error code for mdiobus_read(bus, addr, MII_PHYSID1). If it is EIO and
> maybe ENODEV, set *phy_id to 0xffffffff and return. The scan code
> should then do the correct thing.
>
That could work indeed. Do you want me to test and send a patch?
--
Alexandre Belloni, Bootlin (formerly Free Electrons)
Embedded Linux and Kernel engineering
https://bootlin.com
