Hi Mathieu, On 10 March 2018 at 14:02, Mathieu Malaterre <malat@xxxxxxxxxx> wrote: > On Fri, Mar 9, 2018 at 4:12 PM, Ezequiel Garcia > <ezequiel@xxxxxxxxxxxxxxxxxxxx> wrote: >> This patchset adds support for SD/MMC on JZ4780 based >> platforms, such as the MIPS Creator CI20 board. >> >> Most of the work has been done by Alex, Paul and Zubair, >> while I've only prepared the upstream submission, cleaned >> some patches, and written some commit logs where needed. >> >> All praises should go to them, all rants to me. >> >> The series is based on v4.16-rc4. >> >> Alex Smith (3): >> mmc: jz4740: Set clock rate to mmc->f_max rather than JZ_MMC_CLK_RATE >> mmc: jz4740: Add support for the JZ4780 >> mmc: jz4740: Fix race condition in IRQ mask update >> >> Ezequiel Garcia (9): >> mmc: jz4780: Order headers alphabetically >> mmc: jz4740: Use dev_get_platdata >> mmc: jz4740: Introduce devicetree probe >> mmc: dt-bindings: add MMC support to JZ4740 SoC >> mmc: jz4740: Use dma_request_chan() >> MIPS: dts: jz4780: Add DMA controller node to the devicetree >> MIPS: dts: jz4780: Add MMC controller node to the devicetree >> MIPS: dts: ci20: Enable DMA and MMC in the devicetree >> MIPS: configs: ci20: Enable DMA and MMC support >> >> Paul Cercueil (1): >> mmc: jz4740: Fix error exit path in driver's probe >> >> Zubair Lutfullah Kakakhel (1): >> mmc: jz4740: Reset the device requesting the interrupt > > Nice work. Entire series works just fine on my MIPS Creator CI20 (v1). > Cool. This means a Tested-by for the entire series? > Nitpick: could you update the email addresses: > > s/imgtec/mips/ > You sure that is appropriate? First of all, the work has done under Imagination Technologies umbrella (even if now the developers work for MIPS). And second, I'd feel better if such request would come from the authors, or at least acked by them. Thanks for testing! -- Ezequiel García, VanguardiaSur www.vanguardiasur.com.ar
