On Mon, Jul 03, 2017 at 12:40:49AM +0200, Hauke Mehrtens wrote: > This driver starts the DWC2 core(s) built into the XWAY SoCs and provides > the PHY interfaces for each core. The phy instances can be passed to the > dwc2 driver, which already supports the generic phy interface. > > Signed-off-by: Hauke Mehrtens <hauke@xxxxxxxxxx> > Cc: Kishon Vijay Abraham I <kishon@xxxxxx> > --- > .../bindings/phy/phy-lantiq-rcu-usb2.txt | 42 ++++ > arch/mips/lantiq/xway/sysctrl.c | 24 +- > drivers/phy/Kconfig | 8 + > drivers/phy/Makefile | 1 + > drivers/phy/phy-lantiq-rcu-usb2.c | 275 +++++++++++++++++++++ > 5 files changed, 338 insertions(+), 12 deletions(-) > create mode 100644 Documentation/devicetree/bindings/phy/phy-lantiq-rcu-usb2.txt > create mode 100644 drivers/phy/phy-lantiq-rcu-usb2.c > > diff --git a/Documentation/devicetree/bindings/phy/phy-lantiq-rcu-usb2.txt b/Documentation/devicetree/bindings/phy/phy-lantiq-rcu-usb2.txt > new file mode 100644 > index 000000000000..c538baa2ba54 > --- /dev/null > +++ b/Documentation/devicetree/bindings/phy/phy-lantiq-rcu-usb2.txt > @@ -0,0 +1,42 @@ > +Lantiq XWAY SoC RCU USB 1.1/2.0 PHY binding > +=========================================== > + > +This binding describes the USB PHY hardware provided by the RCU module on the > +Lantiq XWAY SoCs. > + > +This driver has to be a sub node of the Lantiq RCU block. > + > +------------------------------------------------------------------------------- > +Required properties (controller (parent) node): > +- compatible : Should be one of > + "lantiq,ase-usb2-phy" > + "lantiq,danube-usb2-phy" > + "lantiq,xrx100-usb2-phy" > + "lantiq,xrx200-usb2-phy" > + "lantiq,xrx300-usb2-phy" > +- offset-phy : Offset of the USB PHY configuration register > +- offset-ana : Offset of the USB Analog configuration register These are not needed with the reg property used instead. Rob
