On Mon, Jul 3, 2017 at 1:40 AM, Hauke Mehrtens <hauke@xxxxxxxxxx> wrote: > From: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx> > > The reset controllers (on xRX200 and newer SoCs have two of them) are > provided by the RCU module. This was initially implemented as a simple > reset controller. However, the RCU module provides more functionality > (ethernet GPHYs, USB PHY, etc.), which makes it a MFD device. > The old reset controller driver implementation from > arch/mips/lantiq/xway/reset.c did not honor this fact. > > For some devices the request and the status bits are different. > +Required properties: > +- compatible : Should be one of > + "lantiq,danube-reset" > + "lantiq,xrx200-reset" > +- offset-set : Offset of the reset set register > +- offset-status : Offset of the reset status register Just one side comment (I'm fine with either choice, just for your information). Recently I have reviewed at24 patch which adds a property for getting MAC offset and my reseach ends up with the naming pattern mac-offset (as many others are doing this way). So, perhaps in your case it might make sense to do that way? Anyway, it's a matter of a (bit of a) chaos in DT bindings, whatever you decide users will live with. -- With Best Regards, Andy Shevchenko
