On Wed, May 31, 2017 at 3:13 PM, Hauke Mehrtens <hauke@xxxxxxxxxx> wrote:
> On 05/31/2017 10:05 PM, Rob Herring wrote:
>> On Sun, May 28, 2017 at 08:39:57PM +0200, Hauke Mehrtens wrote:
>>> From: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx>
>>>
>>> This adds the initial documentation for the RCU module (a MFD device
>>> which provides USB PHYs, reset controllers and more).
>>>
>>> The RCU register range is used for multiple purposes. Mostly one device
>>> uses one or multiple register exclusively, but for some registers some
>>> bits are for one driver and some other bits are for a different driver.
>>> With this patch all accesses to the RCU registers will go through
>>> syscon.
>>>
>>> Signed-off-by: Hauke Mehrtens <hauke@xxxxxxxxxx>
>>> ---
>>> .../devicetree/bindings/mips/lantiq/rcu.txt | 97 ++++++++++++++++++++++
>>> 1 file changed, 97 insertions(+)
>>> create mode 100644 Documentation/devicetree/bindings/mips/lantiq/rcu.txt
>>>
>>> diff --git a/Documentation/devicetree/bindings/mips/lantiq/rcu.txt b/Documentation/devicetree/bindings/mips/lantiq/rcu.txt
>>> new file mode 100644
>>> index 000000000000..3e2461262218
>>> --- /dev/null
>>> +++ b/Documentation/devicetree/bindings/mips/lantiq/rcu.txt
>>> @@ -0,0 +1,97 @@
>>> +Lantiq XWAY SoC RCU binding
>>> +===========================
>>> +
>>> +This binding describes the RCU (reset controller unit) multifunction device,
>>> +where each sub-device has it's own set of registers.
>>> +
>>> +The RCU register range is used for multiple purposes. Mostly one device
>>> +uses one or multiple register exclusively, but for some registers some
>>> +bits are for one driver and some other bits are for a different driver.
>>> +With this patch all accesses to the RCU registers will go through
>>> +syscon.
>>> +
>>> +
>>> +-------------------------------------------------------------------------------
>>> +Required properties:
>>> +- compatible : The first and second values must be: "simple-mfd", "syscon"
>>> +- reg : The address and length of the system control registers
>>> +
>>> +
>>> +-------------------------------------------------------------------------------
>>> +Example of the RCU bindings on a xRX200 SoC:
>>> + rcu0: rcu@203000 {
>>> + compatible = "lantiq,rcu-xrx200", "simple-mfd", "syscon";
>>> + reg = <0x203000 0x100>;
>>> + big-endian;
>>> +
>>> + gphy0: gphy@0 {
>>
>> Unit address without reg address is not valid.
>>
>>> + compatible = "lantiq,xrx200a2x-rcu-gphy";
>>> +
>>> + regmap = <&rcu0>;
>>> + offset = <0x20>;
>>
>> Does reg not work instead?
>
> Is it ok to access some registers in this range with a reg = <0x20 0x04>
> setting and some others through syscon? This specific register is only
> used by this gphy, but the reset controller shares the register with
> some other drivers like the watchdog driver.
Yes. The main thing is you need to use reg where you have unit addresses.
For the syscon-reboot, you could also just not describe in DT and have
the reset ctrlr driver register reboot driver. DT is not the only way
to instantiate drivers.
Rob
