Hi Ralf, When patches converting MIPS defconfigs to libata PATA were applied this one got lost somehow. Please consider merging (it applies fine to v4.11-rc1). Best regards, -- Bartlomiej Zolnierkiewicz Samsung R&D Institute Poland Samsung Electronics On Monday, September 14, 2015 05:51:58 PM Bartlomiej Zolnierkiewicz wrote: > IDE subsystem has been deprecated since 2009 and the majority > (if not all) of Linux distributions have switched to use > libata for ATA support exclusively. However there are still > some users (mostly old or/and embedded non-x86 systems) that > have not converted from using IDE subsystem to libata PATA > drivers. This doesn't seem to be good thing in the long-term > for Linux as while there is less and less PATA systems left > in use: > > * testing efforts are divided between two subsystems > > * having duplicate drivers for same hardware confuses users > > This patch converts workpad_defconfig to use libata PATA > drivers. > > Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@xxxxxxxxxxx> > --- > Build tested only. > If you have affected hardware please test. Thank you. > > arch/mips/configs/workpad_defconfig | 8 ++++---- > 1 file changed, 4 insertions(+), 4 deletions(-) > > diff --git a/arch/mips/configs/workpad_defconfig b/arch/mips/configs/workpad_defconfig > index ee4b2be..1b556cd 100644 > --- a/arch/mips/configs/workpad_defconfig > +++ b/arch/mips/configs/workpad_defconfig > @@ -28,10 +28,10 @@ CONFIG_IP_MULTICAST=y > # CONFIG_IPV6 is not set > CONFIG_NETWORK_SECMARK=y > CONFIG_BLK_DEV_RAM=m > -# CONFIG_MISC_DEVICES is not set > -CONFIG_IDE=y > -CONFIG_BLK_DEV_IDECS=m > -CONFIG_IDE_GENERIC=y > +CONFIG_BLK_DEV_SD=y > +CONFIG_ATA=y > +CONFIG_PATA_PCMCIA=m > +CONFIG_PATA_LEGACY=y > CONFIG_NETDEVICES=y > # CONFIG_NETDEV_1000 is not set > # CONFIG_NETDEV_10000 is not set
