This patch adds fw_passed_dtb to arch/mips/ralink to support
CONFIG_MIPS_RAW_APPENDED_DTB. Furthermore it adds a check that __dtb_start is
not the same address as __dtb_end.
Signed-off-by: Tobias Wolf <dev-NTEO@xxxxxxxxx>
---
--- a/arch/mips/ralink/of.c
+++ b/arch/mips/ralink/of.c
@@ -66,13 +66,21 @@
void __init plat_mem_setup(void)
{
+ void *dtb = NULL;
+
set_io_port_base(KSEG1);
/*
* Load the builtin devicetree. This causes the chosen node to be
- * parsed resulting in our memory appearing
+ * parsed resulting in our memory appearing. fw_passed_dtb is used
+ * by CONFIG_MIPS_APPENDED_RAW_DTB as well.
*/
- __dt_setup_arch(__dtb_start);
+ if (fw_passed_dtb)
+ dtb = (void *)fw_passed_dtb;
+ else if (__dtb_start != __dtb_end)
+ dtb = (void *)__dtb_start;
+
+ __dt_setup_arch(dtb);
of_scan_flat_dt(early_init_dt_find_memory, NULL);
if (memory_dtb)
---
This version has been cleaned up based on feedback [1] of John Crispin for the
LEDE Project.
[1] https://github.com/lede-project/source/pull/582#discussion_r90778573
Best regards
Tobias
