On Fri, Jan 15, 2016 at 10:27:14PM +0100, Peter Zijlstra wrote:
> On Fri, Jan 15, 2016 at 09:46:12AM -0800, Paul E. McKenney wrote:
> > On Fri, Jan 15, 2016 at 10:13:48AM +0100, Peter Zijlstra wrote:
>
> > > And the stuff we're confused about is how best to express the difference
> > > and guarantees of these two forms of transitivity and how exactly they
> > > interact.
> >
> > Hoping my memory-barrier.txt patch helps here...
>
> Yes, that seems a good start. But yesterday you raised the 'fun' point
> of two globally ordered sequences connected by a single local link.
The conclusion that I am slowly coming to is that litmus tests should
not be thought of as linear chains, but rather as cycles. If you think
of it as a cycle, then it doesn't matter where the local link is, just
how many of them and how they are connected.
But I will admit that there are some rather strange litmus tests that
challenge this cycle-centric view, for example, the one shown below.
It turns out that herd and ppcmem disagree on the outcome. (The Power
architects side with ppcmem.)
> And I think I'm still confused on LWSYNC (in the smp_wmb case) when one
> of the stores looses a conflict, and if that scenario matters. If it
> does, we should inspect the same case for other barriers.
Indeed. I am still working on how these should be described. My
current thought is to be quite conservative on what ordering is
actually respected, however, the current task is formalizing how
RCU plays with the rest of the memory model.
Thanx, Paul
------------------------------------------------------------------------
PPC Overlapping Group-B sets version 4
""
(* When the Group-B sets from two different barriers involve instructions in
the same thread, within that thread one set must contain the other.
P0 P1 P2
Rx=1 Wy=1 Wz=2
dep. lwsync lwsync
Ry=0 Wz=1 Wx=1
Rz=1
assert(!(z=2))
Forbidden by ppcmem, allowed by herd.
*)
{
0:r1=x; 0:r2=y; 0:r3=z;
1:r1=x; 1:r2=y; 1:r3=z; 1:r4=1;
2:r1=x; 2:r2=y; 2:r3=z; 2:r4=1; 2:r5=2;
}
P0 | P1 | P2 ;
lwz r6,0(r1) | stw r4,0(r2) | stw r5,0(r3) ;
xor r7,r6,r6 | lwsync | lwsync ;
lwzx r7,r7,r2 | stw r4,0(r3) | stw r4,0(r1) ;
lwz r8,0(r3) | | ;
exists
(z=2 /\ 0:r6=1 /\ 0:r7=0 /\ 0:r8=1)
