Describe gpio-rt2880 binding.
Signed-off-by: John Crispin <blogic@xxxxxxxxxxx>
Cc: linux-mips@xxxxxxxxxxxxxx
Cc: devicetree@xxxxxxxxxxxxxxx
Cc: linux-gpio@xxxxxxxxxxxxxxx
---
.../devicetree/bindings/gpio/gpio-rt2880.txt | 40 ++++++++++++++++++++
1 file changed, 40 insertions(+)
create mode 100644 Documentation/devicetree/bindings/gpio/gpio-rt2880.txt
diff --git a/Documentation/devicetree/bindings/gpio/gpio-rt2880.txt b/Documentation/devicetree/bindings/gpio/gpio-rt2880.txt
new file mode 100644
index 0000000..b4acf02
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/gpio-rt2880.txt
@@ -0,0 +1,40 @@
+Ralink SoC GPIO controller bindings
+
+Required properties:
+- compatible:
+ - "ralink,rt2880-gpio" for Ralink controllers
+- #gpio-cells : Should be two.
+ - first cell is the pin number
+ - second cell is used to specify optional parameters (unused)
+- gpio-controller : Marks the device node as a GPIO controller
+- reg : Physical base address and length of the controller's registers
+- interrupt-parent: phandle to the INTC device node
+- interrupts : Specify the INTC interrupt number
+- ralink,num-gpios : Specify the number of GPIOs
+- ralink,register-map : The register layout depends on the GPIO bank and actual
+ SoC type. Register offsets need to be in this order.
+ [ INT, EDGE, RENA, FENA, DATA, DIR, POL, SET, RESET, TOGGLE ]
+
+Optional properties:
+- ralink,gpio-base : Specify the GPIO chips base number
+
+Example:
+
+ gpio0: gpio@600 {
+ compatible = "ralink,rt5350-gpio", "ralink,rt2880-gpio";
+
+ #gpio-cells = <2>;
+ gpio-controller;
+
+ reg = <0x600 0x34>;
+
+ interrupt-parent = <&intc>;
+ interrupts = <6>;
+
+ ralink,gpio-base = <0>;
+ ralink,num-gpios = <24>;
+ ralink,register-map = [ 00 04 08 0c
+ 20 24 28 2c
+ 30 34 ];
+
+ };
--
1.7.10.4
