Some BCM5354 SoCs are running at 200MHz, but it is not possible to read
the clock from a register like it is done on some other SoC in ssb and
bcma. These devices should have a clkfreq nvram configuration value set
to 200, read it and set the clock to the correct value.
Signed-off-by: Hauke Mehrtens <hauke@xxxxxxxxxx>
---
arch/mips/bcm47xx/time.c | 12 ++++++++++++
1 file changed, 12 insertions(+)
diff --git a/arch/mips/bcm47xx/time.c b/arch/mips/bcm47xx/time.c
index 536374d..5e5d797 100644
--- a/arch/mips/bcm47xx/time.c
+++ b/arch/mips/bcm47xx/time.c
@@ -27,10 +27,14 @@
#include <linux/ssb/ssb.h>
#include <asm/time.h>
#include <bcm47xx.h>
+#include <bcm47xx_nvram.h>
void __init plat_time_init(void)
{
unsigned long hz = 0;
+ u16 chip_id = 0;
+ char buf[10];
+ int len;
/*
* Use deterministic values for initial counter interrupt
@@ -43,15 +47,23 @@ void __init plat_time_init(void)
#ifdef CONFIG_BCM47XX_SSB
case BCM47XX_BUS_TYPE_SSB:
hz = ssb_cpu_clock(&bcm47xx_bus.ssb.mipscore) / 2;
+ chip_id = bcm47xx_bus.ssb.chip_id;
break;
#endif
#ifdef CONFIG_BCM47XX_BCMA
case BCM47XX_BUS_TYPE_BCMA:
hz = bcma_cpu_clock(&bcm47xx_bus.bcma.bus.drv_mips) / 2;
+ chip_id = bcm47xx_bus.bcma.bus.chipinfo.id;
break;
#endif
}
+ if (chip_id == 0x5354) {
+ len = bcm47xx_nvram_getenv("clkfreq", buf, sizeof(buf));
+ if (len >= 0 && !strncmp(buf, "200", 4))
+ hz = 100000000;
+ }
+
if (!hz)
hz = 100000000;
--
1.7.10.4
