After the new GPIO handling for the bcm47xx target was introduced
wgt634u.c was not changed.
This patch fixes the following compile error:
arch/mips/bcm47xx/wgt634u.c: In function ‘gpio_interrupt’:
arch/mips/bcm47xx/wgt634u.c:119:2: error: implicit declaration of function ‘gpio_polarity’ [-Werror=implicit-function-declaration]
arch/mips/bcm47xx/wgt634u.c: In function ‘wgt634u_init’:
arch/mips/bcm47xx/wgt634u.c:153:4: error: implicit declaration of function ‘gpio_intmask’ [-Werror=implicit-function-declaration]
Reported-by: Ralf Baechle <ralf@xxxxxxxxxxxxxx>
Signed-off-by: Hauke Mehrtens <hauke@xxxxxxxxxx>
---
arch/mips/bcm47xx/wgt634u.c | 8 ++++++--
1 file changed, 6 insertions(+), 2 deletions(-)
I am planing to remove this entire file, but I haven't come up with
code adding support for most of the boards found in the wild.
diff --git a/arch/mips/bcm47xx/wgt634u.c b/arch/mips/bcm47xx/wgt634u.c
index e9f9ec8..6c28f6d 100644
--- a/arch/mips/bcm47xx/wgt634u.c
+++ b/arch/mips/bcm47xx/wgt634u.c
@@ -11,6 +11,7 @@
#include <linux/leds.h>
#include <linux/mtd/physmap.h>
#include <linux/ssb/ssb.h>
+#include <linux/ssb/ssb_embedded.h>
#include <linux/interrupt.h>
#include <linux/reboot.h>
#include <linux/gpio.h>
@@ -116,7 +117,8 @@ static irqreturn_t gpio_interrupt(int irq, void *ignored)
/* Interrupt are level triggered, revert the interrupt polarity
to clear the interrupt. */
- gpio_polarity(WGT634U_GPIO_RESET, state);
+ ssb_gpio_polarity(&bcm47xx_bus.ssb, 1 << WGT634U_GPIO_RESET,
+ state ? 1 << WGT634U_GPIO_RESET : 0);
if (!state) {
printk(KERN_INFO "Reset button pressed");
@@ -150,7 +152,9 @@ static int __init wgt634u_init(void)
gpio_interrupt, IRQF_SHARED,
"WGT634U GPIO", &bcm47xx_bus.ssb.chipco)) {
gpio_direction_input(WGT634U_GPIO_RESET);
- gpio_intmask(WGT634U_GPIO_RESET, 1);
+ ssb_gpio_intmask(&bcm47xx_bus.ssb,
+ 1 << WGT634U_GPIO_RESET,
+ 1 << WGT634U_GPIO_RESET);
ssb_chipco_irq_mask(&bcm47xx_bus.ssb.chipco,
SSB_CHIPCO_IRQ_GPIO,
SSB_CHIPCO_IRQ_GPIO);
--
1.7.10.4
