Hi Ralf, here is my queue of patches i consider ready for 3.8. Included are mainly fixes for various of the supported platforms and 2 generic MIPS fixes. Please consider pulling this into the upstream-sfr tree. John The following changes since commit 0e4a43ed08e2f44aa7b96aa95d0a540d675483e1: Merge git://git.kernel.org/pub/scm/linux/kernel/git/steve/gfs2-3.0-fixes (2012-11-07 13:38:56 +0100) are available in the git repository at: http://dev.phrozen.org/githttp/mips-next.git mips-next for you to fetch changes up to 0224cde212df4abf251f89c3724a800b1949a774: MIPS: lantiq: adds GPHY firmware loader (2012-11-11 18:47:41 +0100) ---------------------------------------------------------------- Charles Hardin (1): mips/octeon: 16-Bit NOR flash was not being detected during boot Ganesan Ramalingam (1): MIPS: Netlogic: Support for XLR/XLS Fast Message Network Hauke Mehrtens (5): MIPS: BCM47XX: ignore last memory page MIPS: BCM47XX: improve memory size detection MIPS: BCM47xx: read out full board data MIPS: BCM47XX: read sprom without prefix if no ieee80211 core MIPS: BCM47xx: sprom: read values without prefix as fallback Jayachandran C (11): MIPS: Netlogic: select MIPSR2 for XLP MIPS: Netlogic: Enable SUE bit in cores MIPS: Netlogic: Move fdt init to plat_mem_setup MIPS: Netlogic: Fix DMA zone selection for 64-bit MIPS: Netlogic: Fix interrupt table entry init MIPS: Netlogic: Pass cpuid to early_init_secondary MIPS: Netlogic: Update PIC access functions MIPS: Netlogic: Move from u32 cpumask to cpumask_t MIPS: Netlogic: Support for multi-chip configuration MIPS: Netlogic: Make number of nodes configurable MIPS: Netlogic: PIC IRQ handling update for multi-chip John Crispin (6): MIPS: lantiq: unbreak devicetree init MIPS: lantiq: fix bootselect bits on XRX200 SoC MIPS: lantiq: verbose init of dma core MIPS: lantiq: adds xrx200 ethernet clock definition MIPS: lantiq: adds code for booting GPHY MIPS: lantiq: adds GPHY firmware loader Jonas Gorski (5): MIPS: BCM63XX: add and use a clock for PCIe MIPS: BCM63XX: add softreset register description for BCM6358 MIPS: BCM63XX: add core reset helper MIPS: BCM63XX: use the new reset helper MIPS: BCM63XX: move nvram functions into their own file Kelvin Cheung (4): MIPS: Loongson1B: use common clock infrastructure instead of private APIs MIPS: Loongson1B: improve ls1x_serial_setup() MIPS: Loongson1B: Update stmmac_mdio_bus_data MIPS: Loongson1B: Fix a typo Kevin Cernekee (1): MIPS: tlbex: Fix section mismatches Madhusudan Bhat (1): MIPS: oprofile: Support for XLR/XLS processors Shane McDonald (1): MIPS: Move processing of coherency kernel parameters earlier Zi Shen Lim (1): MIPS: perf: Add XLP support for hardware perf. arch/mips/Kconfig | 9 +- arch/mips/bcm47xx/prom.c | 20 +- arch/mips/bcm47xx/setup.c | 11 +- arch/mips/bcm47xx/sprom.c | 780 +++++++++++--------- arch/mips/bcm63xx/Makefile | 7 +- arch/mips/bcm63xx/boards/board_bcm963xx.c | 71 +- arch/mips/bcm63xx/clk.c | 34 +- arch/mips/bcm63xx/nvram.c | 104 +++ arch/mips/bcm63xx/reset.c | 223 ++++++ arch/mips/cavium-octeon/flash_setup.c | 3 +- arch/mips/include/asm/mach-bcm47xx/bcm47xx.h | 4 +- arch/mips/include/asm/mach-bcm63xx/bcm63xx_nvram.h | 35 + arch/mips/include/asm/mach-bcm63xx/bcm63xx_regs.h | 10 + arch/mips/include/asm/mach-bcm63xx/bcm63xx_reset.h | 21 + .../mips/include/asm/mach-bcm63xx/board_bcm963xx.h | 17 - .../mips/include/asm/mach-lantiq/xway/lantiq_soc.h | 3 + arch/mips/include/asm/mach-loongson1/platform.h | 3 +- arch/mips/include/asm/mach-loongson1/regs-clk.h | 7 +- arch/mips/include/asm/mach-netlogic/irq.h | 4 +- arch/mips/include/asm/mach-netlogic/multi-node.h | 54 ++ arch/mips/include/asm/netlogic/common.h | 51 +- arch/mips/include/asm/netlogic/interrupt.h | 2 +- arch/mips/include/asm/netlogic/mips-extns.h | 142 ++++ arch/mips/include/asm/netlogic/xlp-hal/pic.h | 44 +- arch/mips/include/asm/netlogic/xlp-hal/sys.h | 1 - arch/mips/include/asm/netlogic/xlr/fmn.h | 363 +++++++++ arch/mips/include/asm/netlogic/xlr/pic.h | 2 - arch/mips/include/asm/netlogic/xlr/xlr.h | 6 +- arch/mips/kernel/perf_event_mipsxx.c | 124 ++++ arch/mips/lantiq/Kconfig | 4 + arch/mips/lantiq/prom.c | 5 +- arch/mips/lantiq/xway/Makefile | 2 + arch/mips/lantiq/xway/dma.c | 9 +- arch/mips/lantiq/xway/reset.c | 58 +- arch/mips/lantiq/xway/sysctrl.c | 4 + arch/mips/lantiq/xway/xrx200_phy_fw.c | 97 +++ arch/mips/loongson1/Kconfig | 2 +- arch/mips/loongson1/common/clock.c | 159 +--- arch/mips/loongson1/common/platform.c | 10 +- arch/mips/loongson1/ls1b/board.c | 5 +- arch/mips/mm/c-r4k.c | 8 +- arch/mips/mm/tlbex.c | 8 +- arch/mips/netlogic/Kconfig | 28 + arch/mips/netlogic/common/irq.c | 165 +++-- arch/mips/netlogic/common/smp.c | 89 ++- arch/mips/netlogic/common/smpboot.S | 6 +- arch/mips/netlogic/xlp/nlm_hal.c | 67 +- arch/mips/netlogic/xlp/setup.c | 50 +- arch/mips/netlogic/xlp/wakeup.c | 83 ++- arch/mips/netlogic/xlr/Makefile | 4 +- arch/mips/netlogic/xlr/fmn-config.c | 290 ++++++++ arch/mips/netlogic/xlr/fmn.c | 204 +++++ arch/mips/netlogic/xlr/setup.c | 37 +- arch/mips/netlogic/xlr/wakeup.c | 23 +- arch/mips/oprofile/Makefile | 1 + arch/mips/oprofile/common.c | 1 + arch/mips/oprofile/op_model_mipsxx.c | 29 + arch/mips/pci/pci-bcm63xx.c | 34 +- 58 files changed, 2719 insertions(+), 918 deletions(-) create mode 100644 arch/mips/bcm63xx/nvram.c create mode 100644 arch/mips/bcm63xx/reset.c create mode 100644 arch/mips/include/asm/mach-bcm63xx/bcm63xx_nvram.h create mode 100644 arch/mips/include/asm/mach-bcm63xx/bcm63xx_reset.h create mode 100644 arch/mips/include/asm/mach-netlogic/multi-node.h create mode 100644 arch/mips/include/asm/netlogic/xlr/fmn.h create mode 100644 arch/mips/lantiq/xway/xrx200_phy_fw.c create mode 100644 arch/mips/netlogic/xlr/fmn-config.c create mode 100644 arch/mips/netlogic/xlr/fmn.c
