This adds support for serial console to bcma, when operating on an SoC.
Signed-off-by: Hauke Mehrtens <hauke@xxxxxxxxxx>
---
drivers/bcma/bcma_private.h | 8 ++++
drivers/bcma/driver_chipcommon.c | 48 +++++++++++++++++++++++++++
drivers/bcma/driver_chipcommon_pmu.c | 26 ++++++++++++++
drivers/bcma/driver_mips.c | 1 +
include/linux/bcma/bcma_driver_chipcommon.h | 14 ++++++++
5 files changed, 97 insertions(+), 0 deletions(-)
diff --git a/drivers/bcma/bcma_private.h b/drivers/bcma/bcma_private.h
index b97633d..22d3052 100644
--- a/drivers/bcma/bcma_private.h
+++ b/drivers/bcma/bcma_private.h
@@ -29,6 +29,14 @@ void bcma_init_bus(struct bcma_bus *bus);
/* sprom.c */
int bcma_sprom_get(struct bcma_bus *bus);
+/* driver_chipcommon.c */
+#ifdef CONFIG_BCMA_DRIVER_MIPS
+void bcma_chipco_serial_init(struct bcma_drv_cc *cc);
+#endif /* CONFIG_BCMA_DRIVER_MIPS */
+
+/* driver_chipcommon_pmu.c */
+u32 bcma_pmu_alp_clock(struct bcma_drv_cc *cc);
+
#ifdef CONFIG_BCMA_HOST_PCI
/* host_pci.c */
extern int __init bcma_host_pci_init(void);
diff --git a/drivers/bcma/driver_chipcommon.c b/drivers/bcma/driver_chipcommon.c
index 75f1ad7..12b42ea 100644
--- a/drivers/bcma/driver_chipcommon.c
+++ b/drivers/bcma/driver_chipcommon.c
@@ -106,3 +106,51 @@ u32 bcma_chipco_gpio_polarity(struct bcma_drv_cc *cc, u32 mask, u32 value)
{
return bcma_cc_write32_masked(cc, BCMA_CC_GPIOPOL, mask, value);
}
+
+#ifdef CONFIG_BCMA_DRIVER_MIPS
+void bcma_chipco_serial_init(struct bcma_drv_cc *cc)
+{
+ unsigned int irq;
+ u32 baud_base;
+ u32 i;
+ unsigned int ccrev = cc->core->id.rev;
+ struct bcma_serial_port *ports = cc->serial_ports;
+
+ if (ccrev >= 11 && ccrev != 15) {
+ /* Fixed ALP clock */
+ baud_base = bcma_pmu_alp_clock(cc);
+ if (ccrev >= 21) {
+ /* Turn off UART clock before switching clocksource. */
+ bcma_cc_write32(cc, BCMA_CC_CORECTL,
+ bcma_cc_read32(cc, BCMA_CC_CORECTL)
+ & ~BCMA_CC_CORECTL_UARTCLKEN);
+ }
+ /* Set the override bit so we don't divide it */
+ bcma_cc_write32(cc, BCMA_CC_CORECTL,
+ bcma_cc_read32(cc, BCMA_CC_CORECTL)
+ | BCMA_CC_CORECTL_UARTCLK0);
+ if (ccrev >= 21) {
+ /* Re-enable the UART clock. */
+ bcma_cc_write32(cc, BCMA_CC_CORECTL,
+ bcma_cc_read32(cc, BCMA_CC_CORECTL)
+ | BCMA_CC_CORECTL_UARTCLKEN);
+ }
+ } else {
+ pr_err("serial not supported on this device ccrev: 0x%x\n",
+ ccrev);
+ return;
+ }
+
+ irq = bcma_core_mips_irq(cc->core);
+
+ /* Determine the registers of the UARTs */
+ cc->nr_serial_ports = (cc->capabilities & BCMA_CC_CAP_NRUART);
+ for (i = 0; i < cc->nr_serial_ports; i++) {
+ ports[i].regs = cc->core->io_addr + BCMA_CC_UART0_DATA +
+ (i * 256);
+ ports[i].irq = irq;
+ ports[i].baud_base = baud_base;
+ ports[i].reg_shift = 0;
+ }
+}
+#endif /* CONFIG_BCMA_DRIVER_MIPS */
diff --git a/drivers/bcma/driver_chipcommon_pmu.c b/drivers/bcma/driver_chipcommon_pmu.c
index dd5846b..59d2b26 100644
--- a/drivers/bcma/driver_chipcommon_pmu.c
+++ b/drivers/bcma/driver_chipcommon_pmu.c
@@ -136,3 +136,29 @@ void bcma_pmu_init(struct bcma_drv_cc *cc)
bcma_pmu_swreg_init(cc);
bcma_pmu_workarounds(cc);
}
+
+u32 bcma_pmu_alp_clock(struct bcma_drv_cc *cc)
+{
+ struct bcma_bus *bus = cc->core->bus;
+
+ switch (bus->chipinfo.id) {
+ case 0x4716:
+ case 0x4748:
+ case 47162:
+ case 0x4313:
+ case 0x5357:
+ case 0x4749:
+ case 53572:
+ /* always 20Mhz */
+ return 20000 * 1000;
+ case 0x5356:
+ case 0x5300:
+ /* always 25Mhz */
+ return 25000 * 1000;
+ default:
+ pr_warn("No ALP clock specified for %04X device, "
+ "pmu rev. %d, using default %d Hz\n",
+ bus->chipinfo.id, cc->pmu.rev, BCMA_CC_PMU_ALP_CLOCK);
+ }
+ return BCMA_CC_PMU_ALP_CLOCK;
+}
diff --git a/drivers/bcma/driver_mips.c b/drivers/bcma/driver_mips.c
index 4b60c9f9..b17233c 100644
--- a/drivers/bcma/driver_mips.c
+++ b/drivers/bcma/driver_mips.c
@@ -238,6 +238,7 @@ void bcma_core_mips_init(struct bcma_drv_mips *mcore)
if (mcore->setup_done)
return;
+ bcma_chipco_serial_init(&bus->drv_cc);
bcma_core_mips_flash_detect(mcore);
mcore->setup_done = true;
}
diff --git a/include/linux/bcma/bcma_driver_chipcommon.h b/include/linux/bcma/bcma_driver_chipcommon.h
index 03cde8d..b9a930e 100644
--- a/include/linux/bcma/bcma_driver_chipcommon.h
+++ b/include/linux/bcma/bcma_driver_chipcommon.h
@@ -241,6 +241,9 @@
#define BCMA_CC_SPROM 0x0800 /* SPROM beginning */
#define BCMA_CC_SPROM_PCIE6 0x0830 /* SPROM beginning on PCIe rev >= 6 */
+/* ALP clock on pre-PMU chips */
+#define BCMA_CC_PMU_ALP_CLOCK 20000000
+
/* Data for the PMU, if available.
* Check availability with ((struct bcma_chipcommon)->capabilities & BCMA_CC_CAP_PMU)
*/
@@ -255,6 +258,14 @@ struct bcma_pflash {
u32 window;
u32 window_size;
};
+
+struct bcma_serial_port {
+ void *regs;
+ unsigned long clockspeed;
+ unsigned int irq;
+ unsigned int baud_base;
+ unsigned int reg_shift;
+};
#endif /* CONFIG_BCMA_DRIVER_MIPS */
struct bcma_drv_cc {
@@ -268,6 +279,9 @@ struct bcma_drv_cc {
struct bcma_chipcommon_pmu pmu;
#ifdef CONFIG_BCMA_DRIVER_MIPS
struct bcma_pflash pflash;
+
+ int nr_serial_ports;
+ struct bcma_serial_port serial_ports[4];
#endif /* CONFIG_BCMA_DRIVER_MIPS */
};
--
1.7.4.1
