Remove a few GPIO register accesses in the board init code with calls to the gpio api. Signed-off-by: Manuel Lauss <mano@xxxxxxxxxxxxxxxxxxxxxxx> --- arch/mips/alchemy/xxs1500/board_setup.c | 18 ++++++++++-------- 1 files changed, 10 insertions(+), 8 deletions(-) diff --git a/arch/mips/alchemy/xxs1500/board_setup.c b/arch/mips/alchemy/xxs1500/board_setup.c index a2634fa..ed7d999 100644 --- a/arch/mips/alchemy/xxs1500/board_setup.c +++ b/arch/mips/alchemy/xxs1500/board_setup.c @@ -23,6 +23,7 @@ * 675 Mass Ave, Cambridge, MA 02139, USA. */ +#include <linux/gpio.h> #include <linux/init.h> #include <linux/delay.h> @@ -65,20 +66,21 @@ void __init board_setup(void) au_writel(0x01, UART3_ADDR + UART_MCR); /* UART_MCR_DTR is 0x01??? */ #ifdef CONFIG_PCMCIA_XXS1500 - /* Setup PCMCIA signals */ - au_writel(0, SYS_PININPUTEN); + alchemy_gpio2_enable(); /* GPIO 0, 1, and 4 are inputs */ - au_writel(1 | (1 << 1) | (1 << 4), SYS_TRIOUTCLR); + alchemy_gpio_direction_input(0); + alchemy_gpio_direction_input(1); + alchemy_gpio_direction_input(4); - /* Enable GPIO2 if not already enabled */ - au_writel(1, GPIO2_ENABLE); /* GPIO2 208/9/10/11 are inputs */ - au_writel((1 << 8) | (1 << 9) | (1 << 10) | (1 << 11), GPIO2_DIR); + alchemy_gpio_direction_input(208); + alchemy_gpio_direction_input(209); + alchemy_gpio_direction_input(210); + alchemy_gpio_direction_input(211); /* Turn off power */ - au_writel((au_readl(GPIO2_PINSTATE) & ~(1 << 14)) | (1 << 30), - GPIO2_OUTPUT); + alchemy_gpio_direction_output(214, 0); #endif #ifdef CONFIG_PCI -- 1.6.3.1
