|
Hi All, i am using the sanblaze card
configured in the kernel for the fiberchannel. i enabled the mpt fusion fc and
the ioctl driver, i also enable scsi disk support, ... I get an error and it hangs. Has any one used the
sanblaze fc driver in the kernel (I am using kernel version 2.6.17.7) Thx, Bill Azer i tried loading the drivers
and get this error : bash-2.05b# insmod
drivers/message/fusion/mptbase.ko Fusion MPT base driver
3.03.09 Copyright (c) 1999-2005 LSI
Logic Corporation bash-2.05b# insmod
drivers/message/fusion/mptctl.ko Fusion MPT misc device
(ioctl) driver 3.03.09 mptctl: Registered with
Fusion MPT base driver mptctl: /dev/mptctl @
(major,minor=10,220) bash-2.05b# insmod
drivers/message/fusion/mptscsih.ko bash-2.05b# insmod
drivers/scsi/scsi_transport_fc.ko bash-2.05b# insmod /lib/modules/2.6.17.7/kernel/drivers/message/fusion/mptfc.ko Fusion MPT FC Host driver
3.03.09 mptbase: Initiating ioc0
bringup ioc0: FC929:
Capabilities={Initiator,Target,LAN} mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (0)! mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (0)! mptbase: Initiating ioc0
recovery mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (130)! mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (65)! mptbase: Initiating ioc0
recovery mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (0)! mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (65)! mptbase: Initiating ioc0
recovery mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (0)! scsi0 : ioc0: LSIFC929,
FwRev=02000a00h, Ports=1, MaxQ=1023, IRQ=10 mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (65)! mptbase: Initiating ioc0
recovery mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (0)! mptbase: mpt_reply: WARNING
- ioc0: Invalid cb_idx (65)! |
