Hello.
Russell King wrote:
BTW, can anybody enlighten me why 8250_au1x00.c came into being
at all?
Its only function seems to register the UART platform devices, the
thing
that is usually done in the board setup code, i. e. I'd rather have
it in arch/mips/au1000/common/platform.c (however, 8250.c should
have been able to filter out ports with UPIO_AU in case
CONFIG_SERIAL_8250_AU1X00 undefined)...
Seemed like a good idea at the moment to follow the already existing
convention.
Already existing convention is as per Sergei's mail actually - to have the
platform device registration in arch/*. The others which you thought were
convention there (accent, boca, fourport, hub6, mca) are all for add-in
cards and aren't architecture specific.
Hence, they can't live in arch/*.
So yes, 8250_au1x00.c breaks the established convention because it isn't
an add-in card.
Thanks for clarification.
Now another question to Pantelis: IIUC, the Alchemy UART platform devices
have UPF_SKIP_TEST set because of the Alchemy docs claiming that UARTs other
than UART3 don't have MCR/MSR and only UART3 does have the full set of the
modem control/status lines? Were they indeed failing the loopback test for
you? Asking because on DBAu1550 board all (enabled) UARTs do pass the loopback
test if I get rid of this flag (however, Au1550 datasheet says MCR/MSR exists
on all UARTs, just no modem pins exist on UART0, and only RTS-/CTS- pair on
UART1 -- and the bits having no correspoding pins seem to be tied high
internally).
If I'm correct, the driver seems inconsistent in how it handles
UART_BUG_NOMSR flag, only checking it when deciding whether to enable the
modem status interrupts or not while actually it should have been checked in
serial8250_set_mctrl() and check_modem_status() as well...
It also looks like the driver doesn't use Alchemy UARTs to their full
potential currently: UART3 has not only full set of modem lines, but also is
capable of the auto flow control (UART1 on Au1550 also is). (Making use of
these features howewer are complicated by the auto flow control being only
available in the late steppings of Au1500 and UART3 modem pins being
multiplexed with GPIO...)
WBR, Sergei
PS: CCing linux-mips to keep people here informed. :-)
