Alchemy CPU counter ticks at the full CPU clock speed, not at the halved one
-- this is not an issue with the current kernel since Alchemy uses its own
timer handler here which pays no attention to mips_hpt_frequency.
Signed-off-by: Sergei Shtylyov <sshtylyov@xxxxxxxxxxxxx>
---
I joined this fix to the arch/mips/au1000/common/time.c cleanup patch
previously but its earlier verison has been finally committed, so here's the
recast which fixes the warning about the 'count' variable being unused...
Index: linux-mips/arch/mips/au1000/common/time.c
===================================================================
--- linux-mips.orig/arch/mips/au1000/common/time.c
+++ linux-mips/arch/mips/au1000/common/time.c
@@ -231,7 +231,6 @@ wakeup_counter0_set(int ticks)
*/
unsigned long cal_r4koff(void)
{
- unsigned long count;
unsigned long cpu_speed;
unsigned long flags;
unsigned long counter;
@@ -258,7 +257,7 @@ unsigned long cal_r4koff(void)
#if defined(CONFIG_AU1000_USE32K)
{
- unsigned long start, end;
+ unsigned long start, end, count;
start = au_readl(SYS_RTCREAD);
start += 2;
@@ -282,7 +281,6 @@ unsigned long cal_r4koff(void)
#else
cpu_speed = (au_readl(SYS_CPUPLL) & 0x0000003f) *
AU1000_SRC_CLK;
- count = cpu_speed / 2;
#endif
}
else {
@@ -291,10 +289,9 @@ unsigned long cal_r4koff(void)
* NOTE: some old silicon doesn't allow reading the PLL.
*/
cpu_speed = (au_readl(SYS_CPUPLL) & 0x0000003f) * AU1000_SRC_CLK;
- count = cpu_speed / 2;
no_au1xxx_32khz = 1;
}
- mips_hpt_frequency = count;
+ mips_hpt_frequency = cpu_speed;
// Equation: Baudrate = CPU / (SD * 2 * CLKDIV * 16)
set_au1x00_uart_baud_base(cpu_speed / (2 * ((int)(au_readl(SYS_POWERCTRL)&0x03) + 2) * 16));
spin_unlock_irqrestore(&time_lock, flags);
