On Wed, 2006-05-03 at 08:59 -0600, Jordan Crouse wrote: > > The last one. In au1xmmc_irq() the status register is read with the > > SD_STATUS_RAT bit set. > > Ok - so the card is timing out. That could be a series of problems, some > of which could be hardware, some of which could be software. Since you are > using a db1200, I'll rule out hardware for the moment, unless you have a > modified board. Today I tested a third SD card from SanDisk, 128MB, same problem and log output (time out in command 9). > Do MMC cards work? Try one - that will give us another data point. Today I received a SanDisk 64 MB MMC card, it doesn't work either. Here the log output: au1xx(0): DEBUG: set_ios (power=0, clock=0Hz, vdd=0, mode=1) au1xxx-mmc: MMC Controller 0 set up at B0600000 (mode=dma) au1xx(0): DEBUG: set_ios (power=1, clock=0Hz, vdd=23, mode=1) au1xx(0): DEBUG: set_ios (power=2, clock=450000Hz, vdd=23, mode=1) au1xx(0): DEBUG: set_ios (power=2, clock=450000Hz, vdd=23, mode=1) MMC: starting cmd 00 arg 00000000 flags 00000040 MMC: req done (00): 0: 00000000 00000000 00000000 00000000 au1xx(0): DEBUG: set_ios (power=2, clock=450000Hz, vdd=23, mode=1) MMC: starting cmd 37 arg 00000000 flags 00000015 au1xx(0): DEBUG: au1xmmc_irq(), SD_STATUS_RAT set MMC: req done (37): 1: 00000000 00000000 00000000 00000000 MMC: starting cmd 37 arg 00000000 flags 00000015 au1xx(0): DEBUG: au1xmmc_irq(), SD_STATUS_RAT set MMC: req done (37): 1: 00000000 00000000 00000000 00000000 MMC: starting cmd 37 arg 00000000 flags 00000015 au1xx(0): DEBUG: au1xmmc_irq(), SD_STATUS_RAT set MMC: req done (37): 1: 00000000 00000000 00000000 00000000 MMC: starting cmd 37 arg 00000000 flags 00000015 au1xx(0): DEBUG: au1xmmc_irq(), SD_STATUS_RAT set MMC: req done (37): 1: 00000000 00000000 00000000 00000000 MMC: mmc_setup(), send_app_op_cond, ocr = 1000fc00, err = 1 MMC: mmc_setup(), no SD card found (1) MMC: starting cmd 01 arg 00000000 flags 00000061 au1xx(0): DEBUG: au1xmmc_irq(), SD_STATUS_RAT set MMC: req done (01): 1: 00000000 00000000 00000000 00000000 MMC: mmc_rescan(): no card found! au1xx(0): DEBUG: set_ios (power=0, clock=0Hz, vdd=0, mode=1) Thanks, Wolfgang
