Hello Michael, Support for bigsur was merged into linux-mips.org some time ago. There's even a defconfig file for it. One known issue with running linux though - you need to have the latest version of CFE installed on the board (1.2.5). Hope this helps, Mark -----Original Message----- From: linux-mips-bounce@xxxxxxxxxxxxxx [mailto:linux-mips-bounce@xxxxxxxxxxxxxx] On Behalf Of Michael J. Hammel Sent: Tuesday, January 17, 2006 11:22 AM To: linux-mips@xxxxxxxxxxxxxx Subject: Broadcom Bigsur build Does anyone have a sample config file for use with 2.6.14.6 that boots a BigSur board? I've tried this kernel using the mips patch (via Cross Linux From Scratch) but the boot locks up right after printing the board type: CFE> boot -elf 172.22.251.154:vmlinux-2.6.14.6 Loader:elf Filesys:tftp Dev:eth0 File:172.22.251.154:vmlinux-2.6.14.6 Options:()Loading: 0xffffffff80100000/3596456 0xffffffff8046e0a8/307112 Entry at 0x8043400Closing network. Starting program at 0x80434000 [RUN!] Broadcom SiByte BCM1480 S0 (pass1) @ 600 MHz (SB-1A rev 0) Board type: SiByte BCM91x80A/B (BigSur) -- Michael J. Hammel <mips@xxxxxxxxxxxxxxxxx>
