On Sat, Dec 15, 2001 at 11:01:50PM +0100, Karsten Merker wrote:
> Hallo everyone,
>
> I cannot get delo to boot any recently built kernel - delo loads
> /etc/delo.conf, finds the correct kernel image and loads it,
> printing "Loading /boot/vmlinux ....... ok", but when the kernel
> itself should be startet (and print "This DECstation is a ...."),
> I get the firmware prompt again.
Have a look at the elf file with readelf - It shows a section which has
a len > 0 and the load address is "0" - When copieng the sections i
overwrite important stuff - This is actually a binutils fault not a
delos one. Although i have been told that i can heavily optimize the
stuff by not dealing with the sections rather than segments. I will
change that.
Flo
--
Florian Lohoff flo@rfc822.org +49-5201-669912
Nine nineth on september the 9th Welcome to the new billenium
PGP signature
