Pete Popov wrote: > Carsten Langgaard wrote: > > Pete Popov wrote: > > > > > >>H . J . Lu wrote: > >> > >>>On Wed, Sep 12, 2001 at 11:57:47AM +0200, Carsten Langgaard wrote: > >>> > >>> > >>>>Carsten Langgaard wrote: > >>>> > >>>> > >>>> > >>>>>I have installed your new set of RedHat7.1 RPMs, and tried to build Perl > >>>>>natively. > >>>>>But it fails with the following message: > >>>>> > >>>>>`sh cflags libperl.a toke.o` toke.c > >>>>> CCCMD = gcc -DPERL_CORE -c -fno-strict-aliasing > >>>>>-I/usr/local/include > >>>>>-O2 > >>>>> > >>>>>Cannot allocate 2676168 bytes after allocating 3899765696 bytes > >>>>>make: *** [toke.o] Error 1 > >>>>>error: Bad exit status from /var/tmp/rpm-tmp.43439 (%build) > >>>>> > >>>>>RPM build errors: > >>>>> Bad exit status from /var/tmp/rpm-tmp.43439 (%build) > >>>>> > >>>>> > >>>>> > >>>>I tried to build perl again an now I get this message: > >>>> > >>>>`sh cflags libperl.a toke.o` toke.c > >>>> CCCMD = gcc -DPERL_CORE -c -fno-strict-aliasing > >>>>-I/usr/local/include -O2 > >>>>gcc: Internal error: Terminated (program cc1) > >>>>Please submit a full bug report. > >>>>See <URL:http://bugzilla.redhat.com/bugzilla/> for instructions. > >>>>make: *** [toke.o] Error 1 > >>>>error: Bad exit status from /var/tmp/rpm-tmp.53242 (%build) > >>>> > >>>>RPM build errors: > >>>> Bad exit status from /var/tmp/rpm-tmp.53242 (%build) > >>>> > >>>> > >>>> > >>>It may be a kernel/hardware bug. I have no problem building perl > >>>natively. > >>> > >>Carsten, what board/cpu are you using? > >> > > > > On a Atlas board with a QED RM5261 CPU (little-endian). > > The kernel is based on 2.4.3. > > I would try the exact same userland and kernel version on a different board, > preferably with a different cpu. Rebuild perl natively 10 times. If it works on > the other board, there is a very good chance that this is a board or CPU > problem. Native compiles seem to be very good for stressing the hardware. > Ok, I found the problem, it turn out that I only had 128K swap space, it should have been 128M. So after increasing my swap space, I was able to compile perl. Thanks a lot. /Carsten > > Pete -- _ _ ____ ___ Carsten Langgaard Mailto:carstenl@mips.com |\ /|||___)(___ MIPS Denmark Direct: +45 4486 5527 | \/ ||| ____) Lautrupvang 4B Switch: +45 4486 5555 TECHNOLOGIES 2750 Ballerup Fax...: +45 4486 5556 Denmark http://www.mips.com
